Re: [PATCH] fix misalignment in pxamci

[Marek Vasut <marek.vasut@gmail.com>]

Dne Tuesday 29 of July 2008 08:30:09 pHilipp Zabel napsal(a):
> On Mon, Jul 28, 2008 at 6:23 PM, Uli Luckas <u.luckas@road.de> wrote:
> > On Saturday, 5. July 2008, pHilipp Zabel wrote:
> >> On Sat, Jul 5, 2008 at 2:19 AM, Marek Vasut <marek.vasut@gmail.com> 
wrote:
> >> > Hi,
> >> > Philipp Zabel finally made the pxamci issue clear. It turned out, that
> >> > pxamci needs the DMA destination address to be aligned to 8 bytes. In
> >> > some cases it happened, that the address was aligned to 4 bytes
> >> > causing controller to incorrectly transfer data (and resulting into
> >> > error like "mmc0: unrecognised SCR structure version 1"). The
> >> > following patch allows to debug this issue and moreover fixes it by
> >> > moving one 4 byte entry of mmc_card structure, aligning the DMA
> >> > destination back to 8 bytes.
> >> >
> >> > Signed-off-by: Marek Vasut <marek.vasut@gmail.com>
> >>
> >> We can enable byte aligned transfers on the DMA controller. This is
> >> what I came up with yesterday:
> >> (sorry for wrapped lines - the proper patch should probably be a
> >> combination of both
> >> warning/DALGN handling and and moving something in mmc_card around).
> >
> > Hi Philipp,
> > this driver is not only for pxa27x but for pxa25x as well and pxa25x
> > can't handle unaligned DMA.
> > Shouldn't Marek Vasut's patch be included for the PXA25x case?
>
> Argh, DALGN shouldn't be defined in pxa-regs.h. We really need an
> aligned SCR target then. Pierre, is there any way we can have the MMC
> core align DMA targets for pxa25x?
>
> Just moving elements of the mmc_card structure around seems to be good
> enough, but I fear this will break again as soon as the next person
> forgets about pxamci's special needs on pxa25x.

Well cant we just add some comment to mmc_card .... like "your eyes will bulge 
with horror if you add something before this point"? ;-)
>
> regards
> Philipp