From: Andrew Morton <akpm@linux-foundation.org>
To: Linus Torvalds <torvalds@linux-foundation.org>
Cc: Stephen Rothwell <sfr@canb.auug.org.au>,
linux-next@vger.kernel.org, LKML <linux-kernel@vger.kernel.org>,
Yinghai Lu <yhlu.kernel@gmail.com>
Subject: Re: linux-next: Tree for September 3
Date: Thu, 4 Sep 2008 01:25:44 -0700 [thread overview]
Message-ID: <20080904012544.cabed847.akpm@linux-foundation.org> (raw)
In-Reply-To: <alpine.LFD.1.10.0809040045190.3378@nehalem.linux-foundation.org>
On Thu, 4 Sep 2008 01:02:10 -0700 (PDT) Linus Torvalds <torvalds@linux-foundation.org> wrote:
> So this all looks ok. I'd be happier if you also actually had some actual
> _device_ in the Cardbus slot and reported that that works, but the patch
> clearly
<rummages for ten minutes>
<found it!>
<plugs it in>
cs: pcmcia_socket0: unable to apply power.
pccard: CardBus card inserted into slot 0
pci 0000:07:00.0: supports D1
pci 0000:07:00.0: supports D2
pci 0000:07:00.0: PME# supported from D1 D2 D3hot D3cold
pci 0000:07:00.0: PME# disabled
sony:/home/akpm> lspci -s07:00
07:00.0 Ethernet controller: 3Com Corporation 3cCFE575CT CardBus [Cyclone] (rev 10)
seems OK.
<applies the patch, enables 3c59x.ko>
<reboots, plugs in card>
cs: pcmcia_socket0: unable to apply power.
pccard: CardBus card inserted into slot 0
pci 0000:07:00.0: supports D1
pci 0000:07:00.0: supports D2
pci 0000:07:00.0: PME# supported from D1 D2 D3hot D3cold
pci 0000:07:00.0: PME# disabled
calling vortex_init+0x0/0x9e [3c59x]
3c59x 0000:07:00.0: enabling device (0000 -> 0003)
3c59x 0000:07:00.0: PCI INT A -> GSI 21 (level, low) -> IRQ 21
3c59x: Donald Becker and others.
0000:07:00.0: 3Com PCI 3CCFE575CT Tornado CardBus at f8cb2000.
3c59x 0000:07:00.0: setting latency timer to 64
initcall vortex_init+0x0/0x9e [3c59x] returned 0 after 36 msecs
can't complain about that, apart from the apparently-bogus "unable to
apply power".
next prev parent reply other threads:[~2008-09-04 8:28 UTC|newest]
Thread overview: 50+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-09-03 9:16 linux-next: Tree for September 3 Stephen Rothwell
2008-09-04 2:32 ` [PATCH] hid: fix gyration build error Randy Dunlap
2008-09-04 6:52 ` Jiri Slaby
2008-09-04 8:06 ` Jiri Kosina
2008-09-04 4:42 ` linux-next: Tree for September 3 Andrew Morton
2008-09-04 4:46 ` Andrew Morton
2008-09-04 4:54 ` Andrew Morton
2008-09-04 4:57 ` Stephen Rothwell
2008-09-04 5:05 ` Andrew Morton
2008-09-04 5:20 ` Stephen Rothwell
2008-09-04 6:01 ` Andrew Morton
2008-09-04 7:15 ` Andrew Morton
2008-09-04 7:48 ` Stephen Rothwell
2008-09-04 9:19 ` Alan Cox
2008-09-04 9:21 ` Alan Cox
2008-09-04 11:01 ` Alan Cox
2008-09-04 14:35 ` Alan Cox
2008-09-04 5:26 ` Linus Torvalds
2008-09-04 5:42 ` Andrew Morton
2008-09-04 5:00 ` Stephen Rothwell
2008-09-04 5:21 ` Linus Torvalds
2008-09-04 5:33 ` Andrew Morton
2008-09-04 7:14 ` Yinghai Lu
2008-09-04 8:00 ` Andrew Morton
2008-09-04 8:23 ` Linus Torvalds
2008-09-04 8:02 ` Linus Torvalds
2008-09-04 8:25 ` Andrew Morton [this message]
2008-09-04 8:37 ` Andrew Morton
2008-09-04 9:03 ` Linus Torvalds
2008-09-04 8:50 ` Linus Torvalds
2008-09-04 8:57 ` Andrew Morton
2008-09-04 9:07 ` Linus Torvalds
2008-09-04 17:45 ` Andrew Morton
2008-09-04 18:05 ` Linus Torvalds
2008-09-04 18:34 ` Andrew Morton
2008-09-04 20:31 ` Eric W. Biederman
2008-09-04 20:41 ` Andrew Morton
2008-09-04 21:03 ` Eric W. Biederman
2008-09-04 22:22 ` Andrew Morton
2008-09-04 22:45 ` Thomas Gleixner
2008-09-04 23:17 ` Linus Torvalds
2008-09-05 5:39 ` Arjan van de Ven
2008-09-04 23:17 ` Andrew Morton
2008-09-04 23:25 ` Linus Torvalds
2008-09-04 23:27 ` Thomas Gleixner
2008-09-05 11:04 ` Ingo Molnar
2008-09-05 17:49 ` Andrew Morton
2008-09-09 4:39 ` Jesse Barnes
-- strict thread matches above, loose matches on Subject: below --
2009-09-03 11:59 Stephen Rothwell
2010-09-03 3:52 Stephen Rothwell
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20080904012544.cabed847.akpm@linux-foundation.org \
--to=akpm@linux-foundation.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-next@vger.kernel.org \
--cc=sfr@canb.auug.org.au \
--cc=torvalds@linux-foundation.org \
--cc=yhlu.kernel@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox