Re: [PATCH v3] rfkill-input doesn't work until 5 minutes after boot

[Ivo van Doorn <ivdoorn@gmail.com>]

On Sunday 05 October 2008, Matthew Garrett wrote:
> rfkill-input implements debounce as follows:
> 
>         if (time_after(jiffies, task->last + msecs_to_jiffies(200))) {
> 
> However, task->last is initialised to 0 while jiffies starts at -300*HZ. 
> Any input within 5 minutes of kernel start is therefore ignored. Fix by 
> initialising task->last correctly.
>
> Signed-off-by: Matthew Garrett <mjg@redhat.com>

I am not too happy about the multiple jiffies - HZ/5 statements
regardless of the comment that it should be updated when new tasks are
defined.

But on the other hand I haven't seen any real alternatives yet either,
so I have no objections against this patch either.

Acked-by: Ivo van Doorn <IvDoorn@gmail.com>
 
> ---
> 
> Document the requirement to initialise the struct.
> 
> diff --git a/net/rfkill/rfkill-input.c b/net/rfkill/rfkill-input.c
> index e5b6955..6c7baa0 100644
> --- a/net/rfkill/rfkill-input.c
> +++ b/net/rfkill/rfkill-input.c
> @@ -103,6 +103,8 @@ static void rfkill_schedule_toggle(struct rfkill_task *task)
>  		.desired_state = RFKILL_STATE_UNBLOCKED,	\
>  	}
>  
> +/* Remember to initialise these in rfkill_handler_init if you add any */
> +
>  static DEFINE_RFKILL_TASK(rfkill_wlan, RFKILL_TYPE_WLAN);
>  static DEFINE_RFKILL_TASK(rfkill_bt, RFKILL_TYPE_BLUETOOTH);
>  static DEFINE_RFKILL_TASK(rfkill_uwb, RFKILL_TYPE_UWB);
> @@ -255,6 +257,11 @@ static struct input_handler rfkill_handler = {
>  
>  static int __init rfkill_handler_init(void)
>  {
> +	rfkill_wlan.last = jiffies - HZ/5;
> +	rfkill_bt.last = jiffies - HZ/5;
> +	rfkill_uwb.last = jiffies - HZ/5;
> +	rfkill_wimax.last = jiffies - HZ/5;
> +	rfkill_wwan.last = jiffies - HZ/5;
>  	return input_register_handler(&rfkill_handler);
>  }
>  
>