From: Alan Cox <alan@redhat.com>
To: linux-kernel@vger.kernel.org
Subject: [PATCH 08/19] qla2xxx: Switch to ROM API
Date: Sun, 05 Oct 2008 17:36:52 +0100 [thread overview]
Message-ID: <20081005163649.3799.96955.stgit@localhost.localdomain> (raw)
In-Reply-To: <20081005163302.3799.61899.stgit@localhost.localdomain>
Depends on the pci_enable/disable_rom being exported. Closes #9422
---
drivers/scsi/qla2xxx/qla_init.c | 20 ++++----------------
1 files changed, 4 insertions(+), 16 deletions(-)
diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index ee89ddd..cabc84b 100644
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -134,7 +134,6 @@ int
qla2100_pci_config(scsi_qla_host_t *ha)
{
uint16_t w;
- uint32_t d;
unsigned long flags;
struct device_reg_2xxx __iomem *reg = &ha->iobase->isp;
@@ -146,9 +145,7 @@ qla2100_pci_config(scsi_qla_host_t *ha)
pci_write_config_word(ha->pdev, PCI_COMMAND, w);
/* Reset expansion ROM address decode enable */
- pci_read_config_dword(ha->pdev, PCI_ROM_ADDRESS, &d);
- d &= ~PCI_ROM_ADDRESS_ENABLE;
- pci_write_config_dword(ha->pdev, PCI_ROM_ADDRESS, d);
+ pci_disable_rom(ha->pdev);
/* Get PCI bus information. */
spin_lock_irqsave(&ha->hardware_lock, flags);
@@ -168,7 +165,6 @@ int
qla2300_pci_config(scsi_qla_host_t *ha)
{
uint16_t w;
- uint32_t d;
unsigned long flags = 0;
uint32_t cnt;
struct device_reg_2xxx __iomem *reg = &ha->iobase->isp;
@@ -231,9 +227,7 @@ qla2300_pci_config(scsi_qla_host_t *ha)
pci_write_config_byte(ha->pdev, PCI_LATENCY_TIMER, 0x80);
/* Reset expansion ROM address decode enable */
- pci_read_config_dword(ha->pdev, PCI_ROM_ADDRESS, &d);
- d &= ~PCI_ROM_ADDRESS_ENABLE;
- pci_write_config_dword(ha->pdev, PCI_ROM_ADDRESS, d);
+ pci_disable_rom(ha->pdev);
/* Get PCI bus information. */
spin_lock_irqsave(&ha->hardware_lock, flags);
@@ -253,7 +247,6 @@ int
qla24xx_pci_config(scsi_qla_host_t *ha)
{
uint16_t w;
- uint32_t d;
unsigned long flags = 0;
struct device_reg_24xx __iomem *reg = &ha->iobase->isp24;
@@ -276,9 +269,7 @@ qla24xx_pci_config(scsi_qla_host_t *ha)
pcie_set_readrq(ha->pdev, 2048);
/* Reset expansion ROM address decode enable */
- pci_read_config_dword(ha->pdev, PCI_ROM_ADDRESS, &d);
- d &= ~PCI_ROM_ADDRESS_ENABLE;
- pci_write_config_dword(ha->pdev, PCI_ROM_ADDRESS, d);
+ pci_disable_rom(ha->pdev);
ha->chip_revision = ha->pdev->revision;
@@ -300,7 +291,6 @@ int
qla25xx_pci_config(scsi_qla_host_t *ha)
{
uint16_t w;
- uint32_t d;
pci_set_master(ha->pdev);
pci_try_set_mwi(ha->pdev);
@@ -315,9 +305,7 @@ qla25xx_pci_config(scsi_qla_host_t *ha)
pcie_set_readrq(ha->pdev, 2048);
/* Reset expansion ROM address decode enable */
- pci_read_config_dword(ha->pdev, PCI_ROM_ADDRESS, &d);
- d &= ~PCI_ROM_ADDRESS_ENABLE;
- pci_write_config_dword(ha->pdev, PCI_ROM_ADDRESS, d);
+ pci_disable_rom(ha->pdev);
ha->chip_revision = ha->pdev->revision;
next prev parent reply other threads:[~2008-10-05 16:39 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-10-05 16:34 [PATCH 00/19] Alan's Miscellaneous Tree Alan Cox
2008-10-05 16:35 ` [PATCH 01/19] pcmcia: Fix wireless drivers Alan Cox
2008-10-05 16:35 ` [PATCH 02/19] pcmcia: IRQ_TYPE_EXCLUSIVE is long obsoleted Alan Cox
2008-10-05 16:40 ` Marcel Holtmann
2008-10-17 21:17 ` Dominik Brodowski
2008-10-05 16:35 ` [PATCH 03/19] pcmcia: Whine harder about use of EXCLUSIVE Alan Cox
2008-10-17 21:17 ` Dominik Brodowski
2008-10-05 16:36 ` [PATCH 04/19] ib700wdt: Fix off by one Alan Cox
2008-10-05 16:36 ` [PATCH 05/19] aic7xxx: MHz not Mhz for SI unit pedants Alan Cox
2008-10-05 16:36 ` [PATCH 06/19] hfsplus: O_LARGEFILE checking is missing Alan Cox
2008-10-05 16:36 ` [PATCH 07/19] mtd: intel_dc21285 switch to ROM API Alan Cox
2008-10-05 16:36 ` Alan Cox [this message]
2008-10-05 16:37 ` [PATCH 09/19] mtd: map_rom has NULL erase pointer Alan Cox
2008-10-05 16:37 ` [PATCH 10/19] ibmtr: PCMCIA IBMTR is ok on 64bit Alan Cox
2008-10-05 16:37 ` [PATCH 11/19] mptlan: Kill unused NAA workaround code Alan Cox
2008-10-05 16:37 ` [PATCH 12/19] pxa27x_udc: leak fix Alan Cox
2008-10-05 16:37 ` [PATCH 13/19] serial_8250: pci_enable_device fail is not fully handled Alan Cox
2008-10-05 16:38 ` [PATCH 14/19] parport: quickfix the proc registration bug Alan Cox
2008-10-05 18:10 ` Frans Pop
2008-10-05 18:22 ` Alan Cox
2008-10-05 16:38 ` [PATCH 15/19] email: sort out a consistent email address for contributions and stuff Alan Cox
2008-10-05 16:38 ` [PATCH 16/19] mptsas: remove unneeded check Alan Cox
2008-10-05 16:38 ` [PATCH 17/19] cdc-acm: Add another conexant modem to the quirks Alan Cox
2008-10-05 16:39 ` [PATCH 18/19] modinfo: Remove duplicate modinfo from some drivers Alan Cox
2008-10-06 8:54 ` Adrian Bunk
2008-10-05 16:39 ` [PATCH 19/19] fdomain_cs: Sort out modules with duplicate description Alan Cox
2008-10-17 21:18 ` Dominik Brodowski
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20081005163649.3799.96955.stgit@localhost.localdomain \
--to=alan@redhat.com \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox