[patch 2.6.28-git] mfd: dm355 evm MMC/SD card detection

[David Brownell <david-b@pacbell.net>]

From: David Brownell <dbrownell@users.sourceforge.net>

Support card detect and writeprotect switches on DM355 EVM.

Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Kevin Hilman <khilman@deeprootsystems.com>
---
I'd actually not intended that this driver merge until the
DM355 platform (and EVM board) support merged ... but since
it's in mainline already, best that it match the latest
code in the DaVinci tree (simplifies merge-with-mainline).

--- a/drivers/mfd/dm355evm_msp.c
+++ b/drivers/mfd/dm355evm_msp.c
@@ -107,6 +107,9 @@ static const u8 msp_gpios[] = {
 	MSP_GPIO(0, SWITCH1), MSP_GPIO(1, SWITCH1),
 	MSP_GPIO(2, SWITCH1), MSP_GPIO(3, SWITCH1),
 	MSP_GPIO(4, SWITCH1),
+	/* switches on MMC/SD sockets */
+	MSP_GPIO(1, SDMMC), MSP_GPIO(2, SDMMC),	/* mmc0 WP, nCD */
+	MSP_GPIO(3, SDMMC), MSP_GPIO(4, SDMMC),	/* mmc1 WP, nCD */
 };
 
 #define MSP_GPIO_REG(offset)	(msp_gpios[(offset)] >> 3)
@@ -304,6 +307,13 @@ static int add_children(struct i2c_client *client)
 		gpio_export(gpio, false);
 	}
 
+	/* MMC/SD inputs -- right after the last config input */
+	if (client->dev.platform_data) {
+		void (*mmcsd_setup)(unsigned) = client->dev.platform_data;
+
+		mmcsd_setup(dm355evm_msp_gpio.base + 8 + 5);
+	}
+
 	/* RTC is a 32 bit counter, no alarm */
 	if (msp_has_rtc()) {
 		child = add_child(client, "rtc-dm355evm",