Re: [PATCH] scripts/checksyscalls.sh: only whine perf_counter_open when supported

[Ingo Molnar <mingo@elte.hu>]

* Mike Frysinger <vapier.adi@gmail.com> wrote:

> On Fri, Jun 12, 2009 at 08:05, Ingo Molnar wrote:
> > * Mike Frysinger <vapier@gentoo.org> wrote:
> >> If the port does not support HAVE_PERF_COUNTERS, then they can't
> >> support the perf_counter_open syscall either.  Rather than forcing
> >> everyone to add an ignore (or suffer the warning until they get
> >> around to implementing support), only whine about the syscall when
> >> applicable.
> >
> > No, this patch is wrong - it's really easy to add support: just hook
> > up the syscall. This should happen for every architecture really, so
> > the warning is correct and it should not be patched out.
> >
> > PMU support is not required to get perfcounters support: if an
> > architecture hooks up the syscall it will get generic software
> > counters and the tools will work as well.
> >
> > Profiling falls back to a hrtimer-based sampling method - this is a
> > much better fallback than oprofile's fall-back to the timer tick.
> > This hrtimer based sampling is dynticks/nohz-correct and can go
> > beyond HZ if the architecture supports hrtimers.
> 
> if there is generic support available, why must every arch select 
> HAVE_PERF_COUNTERS in their Kconfig ?

Because we only want to enable it on architectures that have tested 
it. It should only need a syscall addition, but nothing beats having 
tested things, hence we have that additional Kconfig symbol.

Thanks,

	Ingo