From: "Michael S. Zick" <lkml@morethan.org>
To: Linux Kernel Mailing List <linux-kernel@vger.kernel.org>
Cc: Harald Welte <HaraldWelte@viatech.com>,
Dave Jones <davej@redhat.com>,
Linus Torvalds <torvalds@linux-foundation.org>
Subject: TSC features, was: Re: [PATCH 1/2] CPUFREQ: Enable acpi-cpufreq driver for VIA/Centaur CPUs
Date: Mon, 15 Jun 2009 08:10:13 -0500 [thread overview]
Message-ID: <200906150810.15799.lkml@morethan.org> (raw)
In-Reply-To: <alpine.LFD.2.01.0906081128410.6847@localhost.localdomain>
On Mon June 8 2009, Linus Torvalds wrote:
>
> On Mon, 8 Jun 2009, Harald Welte wrote:
> >
> > The VIA/Centaur C7, C7-M and Nano CPU's all support ACPI based cpu p-states
> > using a MSR interface. The Linux driver just never made use of it, since in
> > addition to the check for the EST flag it also checked if the vendor is Intel.
> >
> > Signed-off-by: Harald Welte <HaraldWelte@viatech.com>
> > ---
> > arch/x86/kernel/cpu/cpufreq/acpi-cpufreq.c | 3 ++-
> > 1 files changed, 2 insertions(+), 1 deletions(-)
> >
> > diff --git a/arch/x86/kernel/cpu/cpufreq/acpi-cpufreq.c b/arch/x86/kernel/cpu/cpufreq/acpi-cpufreq.c
> > index 208ecf6..ee03585 100644
> > --- a/arch/x86/kernel/cpu/cpufreq/acpi-cpufreq.c
> > +++ b/arch/x86/kernel/cpu/cpufreq/acpi-cpufreq.c
> > @@ -90,7 +90,8 @@ static int check_est_cpu(unsigned int cpuid)
> > {
> > struct cpuinfo_x86 *cpu = &cpu_data(cpuid);
> >
> > - if (cpu->x86_vendor != X86_VENDOR_INTEL ||
> > + if ((cpu->x86_vendor != X86_VENDOR_INTEL &&
> > + cpu->x86_vendor != X86_VENDOR_CENTAUR) ||
> > !cpu_has(cpu, X86_FEATURE_EST))
>
> Hmm. This all really should be just
>
> static int check_est_cpu(unsigned int cpuid)
> {
> struct cpuinfo_x86 *cpu = &cpu_data(cpuid);
> return cpu_has(cpu, X86_FEATURE_EST);
> }
>
> I suspect, with no vendor tests. That's the whole _point_ of CPU features,
> after all.
>
Following that same logic, shouldn't this chunk be based on CPU features also?
(Spotted while tracking down why the non-stop TSC wasn't being used on VIA):
#if defined (CONFIG_GENERIC_TIME) && defined (CONFIG_X86)
static void tsc_check_state(int state)
{
switch (boot_cpu_data.x86_vendor) {
case X86_VENDOR_AMD:
case X86_VENDOR_INTEL:
/*
* AMD Fam10h TSC will tick in all
* C/P/S0/S1 states when this bit is set.
*/
if (boot_cpu_has(X86_FEATURE_NONSTOP_TSC))
return;
/*FALL THROUGH*/
default:
/* TSC could halt in idle, so notify users */
if (state > ACPI_STATE_C1)
mark_tsc_unstable("TSC halts in idle");
}
}
#else
static void tsc_check_state(int state) { return; }
#endif
Mike
next prev parent reply other threads:[~2009-06-15 13:10 UTC|newest]
Thread overview: 84+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-06-03 4:06 Linux 2.6.30-rc8 Linus Torvalds
2009-06-04 13:56 ` Linux 2.6.30-rc8 [also: VIA Support] Michael S. Zick
2009-06-04 14:58 ` Michael S. Zick
2009-06-04 15:18 ` Linus Torvalds
2009-06-04 15:37 ` Michael S. Zick
2009-06-04 17:45 ` Harald Welte
2009-06-08 5:48 ` Pavel Machek
2009-06-04 16:00 ` Duane Griffin
2009-06-04 16:08 ` Michael S. Zick
2009-06-04 16:13 ` Linus Torvalds
2009-06-04 16:21 ` Michael S. Zick
2009-06-04 17:03 ` Linus Torvalds
2009-06-04 17:07 ` Linus Torvalds
2009-06-04 17:27 ` Michael S. Zick
2009-06-04 17:46 ` Linus Torvalds
2009-06-05 11:06 ` VIA PowerSaver (Re: Linux 2.6.30-rc8 [also: VIA Support]) Harald Welte
2009-06-05 13:41 ` Michael S. Zick
2009-06-06 12:17 ` Linux 2.6.30-rc8 [also: VIA Support] Michael S. Zick
2009-06-06 13:28 ` e_powersaver / underclocking (was Re: Linux 2.6.30-rc8 [also: VIA Support]) Harald Welte
2009-06-06 13:46 ` Michael S. Zick
2009-06-06 13:56 ` Michael S. Zick
2009-06-08 7:53 ` e_powersaver driver considered DANGEROUS " Harald Welte
2009-06-08 6:12 ` Pavel Machek
2009-06-08 10:27 ` [PATCH 1/2] CPUFREQ: Enable acpi-cpufreq driver for VIA/Centaur CPUs Harald Welte
2009-06-08 13:16 ` Matthew Garrett
2009-06-08 18:01 ` Harald Welte
2009-06-08 14:25 ` Michael S. Zick
2009-06-08 14:58 ` Matthew Garrett
2009-06-08 15:08 ` Michael S. Zick
2009-06-08 18:35 ` Linus Torvalds
2009-06-08 18:41 ` Michael S. Zick
2009-06-08 21:32 ` Michael S. Zick
2009-06-09 2:15 ` Harald Welte
2009-06-09 12:26 ` Michael S. Zick
2009-06-09 16:22 ` Chuck Ebbert
2009-06-09 16:45 ` Michael S. Zick
2009-06-15 13:10 ` Michael S. Zick [this message]
2009-06-15 14:25 ` [PATCH, RFC] Re: TSC features, Michael S. Zick
2009-06-08 20:03 ` [PATCH 1/2] CPUFREQ: Enable acpi-cpufreq driver for VIA/Centaur CPUs Michael S. Zick
2009-06-08 21:15 ` Michael S. Zick
2009-06-08 23:48 ` Matthew Garrett
2009-06-09 12:36 ` Michael S. Zick
2009-06-09 16:00 ` Michael S. Zick
2009-06-09 17:51 ` Michael S. Zick
2009-06-09 8:14 ` Linux 2.6.30-rc8 [also: VIA Support] Harald Welte
2009-06-04 17:55 ` Dave Jones
2009-06-05 7:27 ` Harald Welte
2009-06-05 7:41 ` Michael S. Zick
2009-06-05 7:19 ` Harald Welte
2009-06-05 7:27 ` Michael S. Zick
2009-06-05 10:39 ` Harald Welte
2009-06-05 13:18 ` Michael S. Zick
2009-06-08 5:56 ` Pavel Machek
2009-06-04 17:13 ` Michael S. Zick
2009-06-04 17:40 ` Harald Welte
2009-06-04 18:12 ` Michael S. Zick
2009-06-04 19:23 ` Michael S. Zick
2009-06-04 20:32 ` Michael S. Zick
2009-06-05 4:37 ` Michael S. Zick
2009-06-05 9:00 ` Michael S. Zick
2009-06-04 20:33 ` Dave Jones
2009-06-04 21:01 ` Michael S. Zick
2009-06-04 21:24 ` Dave Jones
2009-06-04 21:38 ` Michael S. Zick
2009-06-04 21:43 ` Dave Jones
2009-06-04 22:00 ` Michael S. Zick
2009-06-04 23:26 ` Michael S. Zick
2009-06-05 0:15 ` Dave Jones
2009-06-05 0:27 ` Michael S. Zick
2009-06-05 11:08 ` VIA CPU PCI cache line size (Re: Linux 2.6.30-rc8 [also: VIA Support]) Harald Welte
2009-06-05 13:43 ` Michael S. Zick
2009-06-04 20:16 ` Linux 2.6.30-rc8 [also: VIA Support] Andi Kleen
2009-06-04 20:29 ` Michael S. Zick
2009-06-05 0:33 ` Robert Hancock
2009-06-05 0:52 ` Michael S. Zick
2009-06-05 0:54 ` Robert Hancock
2009-06-05 7:30 ` Harald Welte
2009-06-04 17:08 ` Harald Welte
2009-06-04 17:18 ` Michael S. Zick
2009-06-05 7:24 ` Harald Welte
2009-06-05 7:44 ` Michael S. Zick
2009-06-05 7:52 ` Michael S. Zick
2009-06-04 20:39 ` Gerd Hoffmann
2009-06-05 18:47 ` Linux 2.6.30-rc8 Michael S. Zick
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=200906150810.15799.lkml@morethan.org \
--to=lkml@morethan.org \
--cc=HaraldWelte@viatech.com \
--cc=davej@redhat.com \
--cc=linux-kernel@vger.kernel.org \
--cc=torvalds@linux-foundation.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox