Re: [PATCH 2.6.36] vlan: Avoid hwaccel vlan packets when vid not used

["Matt Carlson" <mcarlson@broadcom.com>]

On Thu, Jan 06, 2011 at 06:43:22PM -0800, Eric Dumazet wrote:
> Le vendredi 07 janvier 2011 ?? 03:41 +0100, Eric Dumazet a ??crit :
> > Le jeudi 06 janvier 2011 ?? 18:29 -0800, Matt Carlson a ??crit :
> > 
> > > Hi Eric.  Sorry for the delay.  I was under the impression that your
> > > problems were software related and that you just needed a revised
> > > version of these VLAN patches I was sending to Michael.  Is this not
> > > true?
> > > 
> > > Having a hardware stat increment suggests this is a new problem.
> > > Maybe I missed it, but I didn't see what hardware you are working
> > > with and whether or not management firmware was enabled.  Could you tell
> > > me that info?
> > > 
> > 
> > Hi Matt
> > 
> > I started a bisection, because I couldnt sleep tonight anyway :(
> > 
> > 14:04.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5715S
> > Gigabit Ethernet (rev a3)
> > 	Subsystem: Hewlett-Packard Company NC326m PCIe Dual Port Adapter
> > 	Flags: bus master, 66MHz, medium devsel, latency 64, IRQ 43
> > 	Memory at fdff0000 (64-bit, non-prefetchable) [size=64K]
> > 	Memory at fdfe0000 (64-bit, non-prefetchable) [size=64K]
> > 	[virtual] Expansion ROM at fdbe0000 [disabled] [size=128K]
> > 	Capabilities: [40] PCI-X non-bridge device
> > 	Capabilities: [48] Power Management version 2
> > 	Capabilities: [50] Vital Product Data
> > 	Capabilities: [58] MSI: Enable+ Count=1/8 Maskable- 64bit+
> > 	Kernel driver in use: tg3
> > 	Kernel modules: tg3
> > 
> > 
> 
> $ ethtool -i eth2
> driver: tg3
> version: 3.115
> firmware-version: 5715s-v3.28
> bus-info: 0000:14:04.0
> $ dmesg | grep ASF
> [    6.220577] tg3 0000:14:04.0: eth2: RXcsums[1] LinkChgREG[0] MIirq[0]
> ASF[0] TSOcap[1]
> [    6.228586] tg3 0000:14:04.1: eth3: RXcsums[1] LinkChgREG[0] MIirq[0]
> ASF[0] TSOcap[1]

Thanks.  So management firmware is disabled.  This should be
straightforward case.

I'm wondering if I'm misunderstanding something though.  You said earlier
that VLAN tagging doesn't work unless you applied my patch.  Is this no
longer true?