Re: pcmcia vs. MECR on pxa25x/sa1111

Pavel Machek
2011-02-04T08:03:50Z

After 2.6.34 changes, __pxa2xx_drv_pcmcia_probe() was replaced by
sa1111_pcmcia_add(). That unfortunately means that configure_sockets()
is not called, leading to MECR not being set properly, leading to
strange crashes.

Tested on pxa255+sa1111, I do not have lubbock board nearby. Perhaps
cleaner solution exists?

Signed-off-by: Pavel Machek <pma@sysgo.com>

---

Here's updated version. I'd prefer not to do too extensive changes as
I do not have lubbock nearby.

--- a/drivers/pcmcia/pxa2xx_base.c
+++ b/drivers/pcmcia/pxa2xx_base.c
@@ -204,7 +204,7 @@ pxa2xx_pcmcia_frequency_change(struct soc_pcmcia_socket *skt,
}
#endif

-static void pxa2xx_configure_sockets(struct device *dev)
+void pxa2xx_configure_sockets(struct device *dev)
{
struct pcmcia_low_level *ops = dev->platform_data;

--- a/drivers/pcmcia/pxa2xx_base.h
+++ b/drivers/pcmcia/pxa2xx_base.h
@@ -1,3 +1,4 @@
int pxa2xx_drv_pcmcia_add_one(struct soc_pcmcia_socket *skt);
void pxa2xx_drv_pcmcia_ops(struct pcmcia_low_level *ops);
+void pxa2xx_configure_sockets(struct device *dev);

--- a/drivers/pcmcia/pxa2xx_lubbock.c
+++ b/drivers/pcmcia/pxa2xx_lubbock.c
@@ -226,6 +226,7 @@ int pcmcia_lubbock_init(struct sa1111_dev *sadev)
lubbock_set_misc_wr((1 << 15) | (1 << 14), 0);

pxa2xx_drv_pcmcia_ops(&lubbock_pcmcia_ops);
+ pxa2xx_configure_sockets(&sadev->dev);
ret = sa1111_pcmcia_add(sadev, &lubbock_pcmcia_ops,
pxa2xx_drv_pcmcia_add_one);
}