[PATCH 1/3] staging: olpc_dcon: remove noinit module variable

[Andres Salomon <dilinger@queued.net>]

This came from Jordan's original 2007 gxfb_dcon commit.  I've never
seen or heard of it actually being used.  Presumably it was once
useful for skipping hardware initialization when reloading the module
over and over during driver development..

Signed-off-by: Andres Salomon <dilinger@queued.net>
---
 drivers/staging/olpc_dcon/olpc_dcon.c |    7 ++-----
 1 files changed, 2 insertions(+), 5 deletions(-)

diff --git a/drivers/staging/olpc_dcon/olpc_dcon.c b/drivers/staging/olpc_dcon/olpc_dcon.c
index 750fe50..cf4b454 100644
--- a/drivers/staging/olpc_dcon/olpc_dcon.c
+++ b/drivers/staging/olpc_dcon/olpc_dcon.c
@@ -36,9 +36,6 @@
 static int resumeline = 898;
 module_param(resumeline, int, 0444);
 
-static int noinit;
-module_param(noinit, int, 0444);
-
 /* Default off since it doesn't work on DCON ASIC in B-test OLPC board */
 static int useaa = 1;
 module_param(useaa, int, 0444);
@@ -90,7 +87,7 @@ static int dcon_hw_init(struct dcon_priv *dcon, int is_init)
 		}
 	}
 
-	if (ver < 0xdc02 && !noinit) {
+	if (ver < 0xdc02) {
 		/* Initialize the DCON registers */
 
 		/* Start with work-arounds for DCON ASIC */
@@ -106,7 +103,7 @@ static int dcon_hw_init(struct dcon_priv *dcon, int is_init)
 		i2c_smbus_write_word_data(client, 0x3b, 0x002b);
 		i2c_smbus_write_word_data(client, 0x41, 0x0101);
 		i2c_smbus_write_word_data(client, 0x42, 0x0101);
-	} else if (!noinit) {
+	} else {
 		/* SDRAM setup/hold time */
 		i2c_smbus_write_word_data(client, 0x3a, 0xc040);
 		i2c_smbus_write_word_data(client, 0x41, 0x0000);
-- 
1.7.2.5