From: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
To: linux-kernel@vger.kernel.org, stable@vger.kernel.org
Cc: Greg KH <gregkh@linuxfoundation.org>,
torvalds@linux-foundation.org, akpm@linux-foundation.org,
alan@lxorguk.ukuu.org.uk, Dave Chinner <dchinner@redhat.com>,
Al Viro <viro@zeniv.linux.org.uk>, Mel Gorman <mgorman@suse.de>
Subject: [ 13/41] vmscan: shrinker->nr updates race and go wrong
Date: Mon, 30 Jul 2012 10:31:12 -0700 [thread overview]
Message-ID: <20120730172902.354851303@linuxfoundation.org> (raw)
In-Reply-To: <20120730172901.306897424@linuxfoundation.org>
From: Greg KH <gregkh@linuxfoundation.org>
3.0-stable review patch. If anyone has any objections, please let me know.
------------------
From: Dave Chinner <dchinner@redhat.com>
commit acf92b485cccf028177f46918e045c0c4e80ee10 upstream.
Stable note: Not tracked in Bugzilla. This patch reduces excessive
reclaim of slab objects reducing the amount of information
that has to be brought back in from disk.
shrink_slab() allows shrinkers to be called in parallel so the
struct shrinker can be updated concurrently. It does not provide any
exclusio for such updates, so we can get the shrinker->nr value
increasing or decreasing incorrectly.
As a result, when a shrinker repeatedly returns a value of -1 (e.g.
a VFS shrinker called w/ GFP_NOFS), the shrinker->nr goes haywire,
sometimes updating with the scan count that wasn't used, sometimes
losing it altogether. Worse is when a shrinker does work and that
update is lost due to racy updates, which means the shrinker will do
the work again!
Fix this by making the total_scan calculations independent of
shrinker->nr, and making the shrinker->nr updates atomic w.r.t. to
other updates via cmpxchg loops.
Signed-off-by: Dave Chinner <dchinner@redhat.com>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: Mel Gorman <mgorman@suse.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
mm/vmscan.c | 45 ++++++++++++++++++++++++++++++++-------------
1 file changed, 32 insertions(+), 13 deletions(-)
--- a/mm/vmscan.c
+++ b/mm/vmscan.c
@@ -251,17 +251,29 @@ unsigned long shrink_slab(struct shrink_
unsigned long total_scan;
unsigned long max_pass;
int shrink_ret = 0;
+ long nr;
+ long new_nr;
+ /*
+ * copy the current shrinker scan count into a local variable
+ * and zero it so that other concurrent shrinker invocations
+ * don't also do this scanning work.
+ */
+ do {
+ nr = shrinker->nr;
+ } while (cmpxchg(&shrinker->nr, nr, 0) != nr);
+
+ total_scan = nr;
max_pass = do_shrinker_shrink(shrinker, shrink, 0);
delta = (4 * nr_pages_scanned) / shrinker->seeks;
delta *= max_pass;
do_div(delta, lru_pages + 1);
- shrinker->nr += delta;
- if (shrinker->nr < 0) {
+ total_scan += delta;
+ if (total_scan < 0) {
printk(KERN_ERR "shrink_slab: %pF negative objects to "
"delete nr=%ld\n",
- shrinker->shrink, shrinker->nr);
- shrinker->nr = max_pass;
+ shrinker->shrink, total_scan);
+ total_scan = max_pass;
}
/*
@@ -269,13 +281,10 @@ unsigned long shrink_slab(struct shrink_
* never try to free more than twice the estimate number of
* freeable entries.
*/
- if (shrinker->nr > max_pass * 2)
- shrinker->nr = max_pass * 2;
-
- total_scan = shrinker->nr;
- shrinker->nr = 0;
+ if (total_scan > max_pass * 2)
+ total_scan = max_pass * 2;
- trace_mm_shrink_slab_start(shrinker, shrink, total_scan,
+ trace_mm_shrink_slab_start(shrinker, shrink, nr,
nr_pages_scanned, lru_pages,
max_pass, delta, total_scan);
@@ -296,9 +305,19 @@ unsigned long shrink_slab(struct shrink_
cond_resched();
}
- shrinker->nr += total_scan;
- trace_mm_shrink_slab_end(shrinker, shrink_ret, total_scan,
- shrinker->nr);
+ /*
+ * move the unused scan count back into the shrinker in a
+ * manner that handles concurrent updates. If we exhausted the
+ * scan, there is no need to do an update.
+ */
+ do {
+ nr = shrinker->nr;
+ new_nr = total_scan + nr;
+ if (total_scan <= 0)
+ break;
+ } while (cmpxchg(&shrinker->nr, nr, new_nr) != nr);
+
+ trace_mm_shrink_slab_end(shrinker, shrink_ret, nr, new_nr);
}
up_read(&shrinker_rwsem);
out:
next prev parent reply other threads:[~2012-07-30 17:32 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-07-30 17:30 [ 00/41] 3.0.39-rc2 stable review Greg Kroah-Hartman
2012-07-30 17:31 ` [ 01/41] cifs: always update the inode cache with the results from a FIND_* Greg Kroah-Hartman
2012-07-30 17:31 ` [ 02/41] ntp: Fix STA_INS/DEL clearing bug Greg Kroah-Hartman
2012-07-30 17:31 ` [ 03/41] mm: fix lost kswapd wakeup in kswapd_stop() Greg Kroah-Hartman
2012-07-30 17:31 ` [ 04/41] MIPS: Properly align the .data..init_task section Greg Kroah-Hartman
2012-07-30 17:31 ` [ 05/41] UBIFS: fix a bug in empty space fix-up Greg Kroah-Hartman
2012-07-30 17:31 ` [ 06/41] dm raid1: fix crash with mirror recovery and discard Greg Kroah-Hartman
2012-07-30 17:31 ` [ 07/41] mm/vmstat.c: cache align vm_stat Greg Kroah-Hartman
2012-07-30 17:31 ` [ 08/41] mm: memory hotplug: Check if pages are correctly reserved on a per-section basis Greg Kroah-Hartman
2012-07-30 17:31 ` [ 09/41] mm: reduce the amount of work done when updating min_free_kbytes Greg Kroah-Hartman
2012-07-30 17:31 ` [ 10/41] mm: vmscan: fix force-scanning small targets without swap Greg Kroah-Hartman
2012-07-30 17:31 ` [ 11/41] vmscan: clear ZONE_CONGESTED for zone with good watermark Greg Kroah-Hartman
2012-07-30 17:31 ` [ 12/41] vmscan: add shrink_slab tracepoints Greg Kroah-Hartman
2012-07-30 17:31 ` Greg Kroah-Hartman [this message]
2012-07-30 17:31 ` [ 14/41] vmscan: reduce wind up shrinker->nr when shrinker cant do work Greg Kroah-Hartman
2012-07-30 17:31 ` [ 15/41] vmscan: limit direct reclaim for higher order allocations Greg Kroah-Hartman
2012-07-30 17:31 ` [ 16/41] vmscan: abort reclaim/compaction if compaction can proceed Greg Kroah-Hartman
2012-07-30 17:31 ` [ 17/41] mm: compaction: trivial clean up in acct_isolated() Greg Kroah-Hartman
2012-07-30 17:31 ` [ 18/41] mm: change isolate mode from #define to bitwise type Greg Kroah-Hartman
2012-07-30 17:31 ` [ 19/41] mm: compaction: make isolate_lru_page() filter-aware Greg Kroah-Hartman
2012-07-30 17:31 ` [ 20/41] mm: zone_reclaim: " Greg Kroah-Hartman
2012-07-30 17:31 ` [ 21/41] mm: migration: clean up unmap_and_move() Greg Kroah-Hartman
2012-07-30 17:31 ` [ 22/41] mm: compaction: allow compaction to isolate dirty pages Greg Kroah-Hartman
2012-07-30 17:31 ` [ 23/41] mm: compaction: determine if dirty pages can be migrated without blocking within ->migratepage Greg Kroah-Hartman
2012-07-30 17:31 ` [ 24/41] mm: page allocator: do not call direct reclaim for THP allocations while compaction is deferred Greg Kroah-Hartman
2012-07-30 17:31 ` [ 25/41] mm: compaction: make isolate_lru_page() filter-aware again Greg Kroah-Hartman
2012-07-30 17:31 ` [ 26/41] kswapd: avoid unnecessary rebalance after an unsuccessful balancing Greg Kroah-Hartman
2012-07-30 17:31 ` [ 27/41] kswapd: assign new_order and new_classzone_idx after wakeup in sleeping Greg Kroah-Hartman
2012-07-30 17:31 ` [ 28/41] mm: compaction: introduce sync-light migration for use by compaction Greg Kroah-Hartman
2012-07-31 16:43 ` Herton Ronaldo Krzesinski
2012-07-31 17:00 ` Greg Kroah-Hartman
2012-07-30 17:31 ` [ 29/41] mm: vmscan: when reclaiming for compaction, ensure there are sufficient free pages available Greg Kroah-Hartman
2012-07-30 17:31 ` [ 30/41] mm: vmscan: do not OOM if aborting reclaim to start compaction Greg Kroah-Hartman
2012-07-30 17:31 ` [ 31/41] mm: vmscan: check if reclaim should really abort even if compaction_ready() is true for one zone Greg Kroah-Hartman
2012-07-30 17:31 ` [ 32/41] vmscan: promote shared file mapped pages Greg Kroah-Hartman
2012-07-30 17:31 ` [ 33/41] vmscan: activate executable pages after first usage Greg Kroah-Hartman
2012-07-30 17:31 ` [ 34/41] mm/vmscan.c: consider swap space when deciding whether to continue reclaim Greg Kroah-Hartman
2012-07-30 17:31 ` [ 35/41] mm: test PageSwapBacked in lumpy reclaim Greg Kroah-Hartman
2012-07-30 17:31 ` [ 36/41] mm: vmscan: convert global reclaim to per-memcg LRU lists Greg Kroah-Hartman
2012-07-30 17:31 ` [ 37/41] cpusets: avoid looping when storing to mems_allowed if one node remains set Greg Kroah-Hartman
2012-07-30 17:31 ` [ 38/41] cpusets: stall when updating mems_allowed for mempolicy or disjoint nodemask Greg Kroah-Hartman
2012-07-30 17:31 ` [ 39/41] cpuset: mm: reduce large amounts of memory barrier related damage v3 Greg Kroah-Hartman
2012-07-30 17:31 ` [ 40/41] mm/hugetlb: fix warning in alloc_huge_page/dequeue_huge_page_vma Greg Kroah-Hartman
2012-07-30 17:31 ` [ 41/41] vmscan: fix initial shrinker size handling Greg Kroah-Hartman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20120730172902.354851303@linuxfoundation.org \
--to=gregkh@linuxfoundation.org \
--cc=akpm@linux-foundation.org \
--cc=alan@lxorguk.ukuu.org.uk \
--cc=dchinner@redhat.com \
--cc=linux-kernel@vger.kernel.org \
--cc=mgorman@suse.de \
--cc=stable@vger.kernel.org \
--cc=torvalds@linux-foundation.org \
--cc=viro@zeniv.linux.org.uk \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox