Re: SPARC and OF_GPIO

[Thierry Reding <thierry.reding@avionic-design.de>]

[-- Attachment #1: Type: text/plain, Size: 2604 bytes --]

On Fri, Nov 30, 2012 at 09:35:20AM +0000, Grant Likely wrote:
> On Wed, 07 Nov 2012 02:34:19 -0500 (EST), David Miller <davem@davemloft.net> wrote:
> > From: Thierry Reding <thierry.reding@avionic-design.de>
> > Date: Wed, 7 Nov 2012 07:52:58 +0100
> > 
> > > It seems like OF_ADDRESS would be trickier. A comment around line 60 in
> > > drivers/of/platform.c says that SPARC doesn't need functions defined in
> > > the enclosing #ifdef CONFIG_OF_ADDRESS block. I'm not sure it would be
> > > acceptable to remove the conflict nonetheless, even if the functions
> > > aren't used. One benefit would be that the code could receive some extra
> > > compile coverage.
> >  ...
> > > Finally, OF_IRQ is again just generic code to map device tree data to
> > > IRQ domains. While I didn't see the IRQ_DOMAIN symbol selected anywhere
> > > in SPARC it should still be possible to run drivers that properly
> > > implement IRQ domains on SPARC, right? Or is there any reason why they
> > > wouldn't work?
> > 
> > These are the two most conflicted areas for Sparc.
> > 
> > For addresses, we fully compute the full fully resolved physical
> > address of all registers of an OF device very early at bootup time
> > when we first scan the device tree.
> > 
> > Same goes for interrupts, we fully compute them early in the bootup
> > process.
> 
> Right. That's the reason I haven't tackled making all architectures do
> the same thing. I've not been confident that I'd get the sparc bits
> correct. I think it could be done, but I haven't been able to wrap my
> brain around it sufficiently.
> 
> On non-sparc I've actually been moving in the direction of resolving
> resources at .probe time to make it easier to handle deferred probing.
> So if, for example, a device irq line is routed to a GPIO instead of the
> core interrupt controller, then the irq number won't be known until
> after the gpio driver .probe occurs. For addresses, this situation is
> unlikely, but for all the other kinds of resources (gpios, regs, clocks, irqs,
> etc) it is a problem that we're actually seeing.

Interesting. I have some I2C devices that run into the problem where
their interrupts cannot be resolved at instantiation time so I've had to
work around it by calling irq_of_parse_and_map() at .probe() time and
return -EPROBE_DEFER if that return NO_IRQ.

Are any of your plans documented somewhere? I'd be interested to know
how this is supposed to be solved. irq_of_parse_and_map() is not going
to work for non-DT setups so the above can't be a proper solution.

Thierry

[-- Attachment #2: Type: application/pgp-signature, Size: 836 bytes --]