Re: [PATCH] blkpm: avoid sleep when holding queue lock

[Jens Axboe <axboe@kernel.dk>]

On Fri, May 17 2013, Aaron Lu wrote:
> In blk_post_runtime_resume, an autosuspend request will be initiated for
> the device. Since we are holding the queue lock, we can't sleep and thus
> we should use the async version to initiate an autosuspend, i.e.
> pm_request_suspend instead of pm_runtime_suspend, which might sleep.
> 
> Signed-off-by: Aaron Lu <aaron.lu@intel.com>
> ---
> I didn't turn on the lock debugging config options while doing test so
> this issue didn't show up until recently I have all those lock debugging
> options turned on, a warning instantly showed up. While it is correctly
> using pm_request_autosuspend in pre-v7 series, and is brought by me
> mistakenly, sorry for this.
> 
>  block/blk-core.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/block/blk-core.c b/block/blk-core.c
> index 33c33bc..d5745b5 100644
> --- a/block/blk-core.c
> +++ b/block/blk-core.c
> @@ -3164,7 +3164,7 @@ void blk_post_runtime_resume(struct request_queue *q, int err)
>  		q->rpm_status = RPM_ACTIVE;
>  		__blk_run_queue(q);
>  		pm_runtime_mark_last_busy(q->dev);
> -		pm_runtime_autosuspend(q->dev);
> +		pm_request_autosuspend(q->dev);
>  	} else {
>  		q->rpm_status = RPM_SUSPENDED;
>  	}
> -- 
> 1.8.3.rc2

Thanks applied, obviously right.

-- 
Jens Axboe