[PATCH 5/8] ARM: sti: move DEBUG_STI_UART into alphabetical order

Arnd Bergmann
2013-07-05T16:22:45Z

This was accidentally added in the wrong place, messing
up the ordering of the file.

Signed-off-by: Arnd Bergmann <arnd@arndb.de>
---
arch/arm/Kconfig.debug | 20 ++++++++++----------
1 file changed, 10 insertions(+), 10 deletions(-)

diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
index 77c1411..ff4920b 100644
--- a/arch/arm/Kconfig.debug
+++ b/arch/arm/Kconfig.debug
@@ -510,6 +510,16 @@ choice
Say Y here if you want the debug print routines to direct
their output to the uart1 port on SiRFmarco devices.

+ config DEBUG_STI_UART
+ depends on ARCH_STI
+ bool "Use StiH415/416 ASC for low-level debug"
+ help
+ Say Y here if you want kernel low-level debugging support
+ on StiH415/416 based platforms like B2000, B2020.
+ It support UART2 and SBC_UART1.
+
+ If unsure, say N.
+
config DEBUG_U300_UART
bool "Kernel low-level debugging messages via U300 UART0"
depends on ARCH_U300
@@ -557,16 +567,6 @@ choice
This option selects UART0 on VIA/Wondermedia System-on-a-chip
devices, including VT8500, WM8505, WM8650 and WM8850.

- config DEBUG_STI_UART
- depends on ARCH_STI
- bool "Use StiH415/416 ASC for low-level debug"
- help
- Say Y here if you want kernel low-level debugging support
- on StiH415/416 based platforms like B2000, B2020.
- It support UART2 and SBC_UART1.
-
- If unsure, say N.
-
config DEBUG_LL_UART_NONE
bool "No low-level debugging UART"
depends on !ARCH_MULTIPLATFORM
--
1.8.3.1