Re: [PATCH 0/5] edac, highbank: Add Calxeda ECX-2000 support

[Robert Richter <rric@kernel.org>]

On 28.10.13 17:06:07, Rob Herring wrote:
> On Wed, Oct 16, 2013 at 5:59 AM, Robert Richter <rric@kernel.org> wrote:
> > This patch series enables ECC edac support for Calxeda ECX-2000
> > (Midway). The ECX-2000 memory controller is similar to Highbank but
> > has different register bases for error and interrupt registers.
> >
> > Testing the driver uncovered a bug in the interrupt initialization.
> > So there is also a fix for this for all the Highbank edac drivers. The
> > interrupt was enabled too early which caused a crash if there are
> > interrupts pending (ECC errors) during driver initialization.
> >
> > Also some improvements and unification of edac log messages I found
> > useful.
> >
> > -Robert
> >
> >
> > Rob Herring (1):
> >   ARM: dts: calxeda: move memory-controller node out of ecx-common.dtsi
> >
> > Robert Richter (4):
> >   edac, highbank: Fix interrupt setup of mem and l2 controller
> >   edac, highbank: Add Calxeda ECX-2000 support
> >   edac, highbank: Improve and unify naming
> >   edac: Unify reporting of device info for device, mc and pci
> 
> For the series:
> 
> Acked-by: Rob Herring <rob.herring@calxeda.com>

Thanks Rob and Boris, I applied the patches here:

 git://git.kernel.org/pub/scm/linux/kernel/git/rric/oprofile.git edac

and will take care of them and send a pull request directly to Linus.

-Robert