From: David Brown <davidb@codeaurora.org>
To: Felipe Balbi <balbi@ti.com>
Cc: "Ivan T. Ivanov" <iivanov@mm-sol.com>,
gregkh@linuxfoundation.org, rob.herring@calxeda.com,
pawel.moll@arm.com, mark.rutland@arm.com, swarren@wwwdotorg.org,
ijc+devicetree@hellion.org.uk, linux-usb@vger.kernel.org,
linux-arm-msm@vger.kernel.org, linux-kernel@vger.kernel.org
Subject: Re: [PATCH v4 00/15] usb: phy: msm: Fixes, cleanups and DT support
Date: Thu, 19 Dec 2013 15:03:15 -0800 [thread overview]
Message-ID: <20131219230315.GA20875@codeaurora.org> (raw)
In-Reply-To: <20131126163846.GF24310@saruman.home>
On Tue, Nov 26, 2013 at 10:38:46AM -0600, Felipe Balbi wrote:
>Hi,
>
>On Tue, Nov 12, 2013 at 04:51:35PM +0200, Ivan T. Ivanov wrote:
>> From: "Ivan T. Ivanov" <iivanov@mm-sol.com>
>>
>> Hi,
>>
>> Patches have been tested on top of Stephen's clock controller
>> patches[1] and recent fixes for chipidea msm glue layer driver
>> posted here[2]. Hardware platform AP8074 DragonBoard. Only gadget
>> mode utilized for now.
>>
>> CV Test Suite engine "Chapter 9 tests" are passing except
>> "Halt Endpoint Test".
>>
>> usbtest driver report following failure:
>> test 13 --> 32 (Broken pipe) ep 81 couldn't set halt, -32
>>
>> This will be investigated further.
>> Patches could be applied cleanly on top of the usb-3.13-rc1.
>>
>> Regards,
>> Ivan
>>
>> [1] http://comments.gmane.org/gmane.linux.ports.arm.msm/5375
>> [2] https://lkml.org/lkml/2013/11/11/310
>
>I wonder how will this be taken upstream provided there are
>interdependencies between arch/ and drivers/ patches.
>
>I can Ack patches but I'd really like to avoid merging of topic branches
>all over the place :-s
Ivan's patches are the only ones in this window that touch these board
files in MSM. It's probably easiest if I ack them, and you can bring
the whole series through your tree.
David
--
sent by an employee of the Qualcomm Innovation Center, Inc.
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation
next prev parent reply other threads:[~2013-12-19 23:03 UTC|newest]
Thread overview: 36+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-11-12 14:51 [PATCH v4 00/15] usb: phy: msm: Fixes, cleanups and DT support Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 01/15] usb: phy: msm: Move mach dependent code to platform data Ivan T. Ivanov
2013-11-12 18:27 ` Christopher Covington
2013-11-12 19:11 ` Ivan T. Ivanov
2013-12-11 10:11 ` Ivan T. Ivanov
2013-12-27 18:10 ` Felipe Balbi
2013-12-27 18:23 ` Stephen Boyd
2013-12-27 18:44 ` Felipe Balbi
2013-11-12 14:51 ` [PATCH v4 02/15] usb: phy: msm: Move global regulators variables to driver state Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 03/15] usb: phy: msm: Migrate to Managed Device Resource allocation Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 04/15] usb: phy: msm: Remove unnecessarily check for valid regulators Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 05/15] usb: phy: msm: Fix checkpatch.pl warnings Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 06/15] usb: phy: msm: Replace custom enum usb_mode_type with enum usb_dr_mode Ivan T. Ivanov
2013-12-19 23:03 ` David Brown
2013-11-12 14:51 ` [PATCH v4 07/15] usb: phy: msm: Remove unused pclk_src_name Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 08/15] usb: phy: msm: Remove HSUSB prefix from regulator names Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 09/15] usb: phy: msm: Properly check result from platform_get_irq() Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 10/15] usb: phy: msm: Add device tree support and binding information Ivan T. Ivanov
2013-11-15 16:38 ` Mark Rutland
2013-11-18 12:54 ` Ivan T. Ivanov
2013-12-05 10:41 ` Mark Rutland
2013-12-11 9:45 ` Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 11/15] usb: phy: msm: Use reset framework for LINK and PHY resets Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 12/15] usb: phy: msm: Add support for secondary PHY control Ivan T. Ivanov
2013-11-15 16:42 ` Mark Rutland
2013-11-18 12:57 ` Ivan T. Ivanov
2013-12-05 10:42 ` Mark Rutland
2013-12-11 8:23 ` Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 13/15] usb: phy: msm: Correct USB PHY Reset sequence for newer platform Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 14/15] usb: phy: msm: Handle disconnect events Ivan T. Ivanov
2013-11-12 14:51 ` [PATCH v4 15/15] usb: phy: msm: Vote for corner of VDD CX instead of voltage of VDD CX Ivan T. Ivanov
2013-11-26 16:38 ` [PATCH v4 00/15] usb: phy: msm: Fixes, cleanups and DT support Felipe Balbi
2013-12-19 23:03 ` David Brown [this message]
2013-12-19 23:26 ` Felipe Balbi
2013-12-20 19:59 ` David Brown
2013-12-27 0:26 ` Stephen Boyd
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20131219230315.GA20875@codeaurora.org \
--to=davidb@codeaurora.org \
--cc=balbi@ti.com \
--cc=gregkh@linuxfoundation.org \
--cc=iivanov@mm-sol.com \
--cc=ijc+devicetree@hellion.org.uk \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-usb@vger.kernel.org \
--cc=mark.rutland@arm.com \
--cc=pawel.moll@arm.com \
--cc=rob.herring@calxeda.com \
--cc=swarren@wwwdotorg.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).