Re: [PATCH 2/2] i2c designware add support of I2C standard mode

[Wolfram Sang <wsa@the-dreams.de>]

[-- Attachment #1: Type: text/plain, Size: 1567 bytes --]

On Tue, Oct 08, 2013 at 05:00:55PM +0200, Romain Baeriswyl wrote:
> Some legacy devices support ony I2C standard mode at 100kHz. 
> This patch allows to select the standard mode through the DTS 
> with the use of the existing clock-frequency parameter.
> 
> When clock-frequency parameter is not set, the fast mode is selected.
> Only when the parameter is set at 100000, the standard mode is selected.
> 
> Signed-off-by: Romain Baeriswyl <romainba@abilis.com>
> Reviewed-by: Christian Ruppert <christian.ruppert@abilis.com>

Pretty much OK. One change needed, though:

> ---
>  .../devicetree/bindings/i2c/i2c-designware.txt     |    1 +
>  drivers/i2c/busses/i2c-designware-platdrv.c        |   17 +++++++++++++++--
>  2 files changed, 16 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/i2c/i2c-designware.txt b/Documentation/devicetree/bindings/i2c/i2c-designware.txt
> index 5199b0c..16d0bef 100644
> --- a/Documentation/devicetree/bindings/i2c/i2c-designware.txt
> +++ b/Documentation/devicetree/bindings/i2c/i2c-designware.txt
> @@ -9,6 +9,7 @@ Required properties :
>  Recommended properties :
>  
>   - clock-frequency : desired I2C bus clock frequency in Hz.
> +   Only standard mode at 100kHz and fast mode at 400kHz are supported.

This should not go the bindings doc, since this is a linux specific
detail. It should go...

> +		if (clk_freq != 100000 && clk_freq != 400000)
> +			return -EINVAL;

... here as an dev_err message "Only x and y supported".

Rest looks good, thanks!


[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 836 bytes --]