Re: Query: Phy: How to find consumer device on dt platform

[Pratyush Anand <pratyush.anand@st.com>]

On Wed, Jan 29, 2014 at 10:24:35PM +0800, Arnd Bergmann wrote:
> On Wednesday 29 January 2014, Pratyush Anand wrote:
> > On Wed, Jan 29, 2014 at 01:41:56PM +0800, Kishon Vijay Abraham I wrote:
> > > > 
> > > > I would instead recommend making the mode of the PHY device the
> > > > argument to the phy handle in DT, so that the sata node uses
> > > > 
> > > > 	phys = <&phyA 0>;
> > > > 
> > > > and the PCIe node uses
> > > > 
> > > > 	phys = <&phyB 1>;
> > > > 
> > > > Then the binding for the phy defines that an argument of '0' means sata mode,
> > > > while '1' means pcie mode, plus you should define all other valid modes.
> > 
> > Probably, it may  not help in this case. How would *phys* defining as
> > above with PCIe/SATA node help phy driver to decide whether current
> > phy instance is associated with PCIe or SATA. Actually, there is no
> > way to pass information from phy consumer driver(pcie/sata driver in
> > this case) to phy driver.
> 
> I don't understand what is unclear about my example where I do just that.
> The argument (0 or 1) gets passed into the driver's xlate function
> when the consumer calls of_phy_get().

May be I did not understand this mechanism earlier.
I got it now. 

Will do this way :)

Thanks for explaining it.

Regards
Pratyush

> 
> > > Anyway phyA and phyB points to different nodes and just from phyA and phyB we
> > > should be able to tell whether it is sata or pcie.
> > 
> > We have multiple instances (say 3) of same phy, which can be
> > programmed either for pcie or for sata. We have multiple instances of
> > ahci and pcie controller. phy_n will be connected to either ahci_n or
> > pcie_n.
> > 
> > What Kishon has suggested here is exactly what I was thinking.
> > I think, we should go with this.
> 
> I still find it highly inconsistent.
> 
> 	Arnd