Re: [PATCH v3 1/3] mfd: add support for Cypress CYUSBS234 USB Serial Bridge controller

[Johan Hovold <johan@kernel.org>]

On Thu, Oct 09, 2014 at 08:40:29AM +0100, Lee Jones wrote:
> On Mon, 06 Oct 2014, Muthu Mani wrote:

> > +static int update_ep_details(struct usb_interface *interface,
> > +				struct cyusbs23x *cyusbs)
> > +{
> > +	struct usb_host_interface *iface_desc;
> > +	struct usb_endpoint_descriptor *ep;
> > +	int i;
> > +
> > +	iface_desc = interface->cur_altsetting;
> > +
> > +	for (i = 0; i < iface_desc->desc.bNumEndpoints; ++i) {
> > +
> > +		ep = &iface_desc->endpoint[i].desc;
> > +
> > +		if (!cyusbs->bulk_in_ep_num && usb_endpoint_is_bulk_in(ep))
> > +			cyusbs->bulk_in_ep_num = ep->bEndpointAddress;
> > +		if (!cyusbs->bulk_out_ep_num && usb_endpoint_is_bulk_out(ep))
> > +			cyusbs->bulk_out_ep_num = ep->bEndpointAddress;
> > +		if (!cyusbs->intr_in_ep_num && usb_endpoint_is_int_in(ep))
> > +			cyusbs->intr_in_ep_num = ep->bEndpointAddress;
> > +	}
> 
> All of the USB specific code in this driver will require a USB Ack.

I'll review it once the incomplete gpio-driver issue has been resolved.

> > +	dev_dbg(&interface->dev, "%s intr_in=%d, bulk_in=%d, bulk_out=%d\n",
> > +		__func__, cyusbs->intr_in_ep_num ,
> > +		cyusbs->bulk_in_ep_num, cyusbs->bulk_out_ep_num);
> > +
> > +	if (!cyusbs->bulk_in_ep_num || !cyusbs->bulk_out_ep_num ||
> > +		!cyusbs->intr_in_ep_num)
> > +		return -ENODEV;
> > +
> > +	return 0;
> > +}

[...]

> > diff --git a/include/linux/mfd/cyusbs23x.h b/include/linux/mfd/cyusbs23x.h

> > +/* Serial interfaces (I2C, SPI, UART) differ in interface subclass */
> > +enum cy_scb_modes {
> > +	CY_USBS_SCB_DISABLED = 0,
> > +	CY_USBS_SCB_UART = 1,
> > +	CY_USBS_SCB_SPI = 2,
> > +	CY_USBS_SCB_I2C = 3
> 
> No need to number these.

As it's not an arbitrary enumeration, I think they should be initialised
explicitly. They could be defined in the mfd driver though, as they only
appear to be needed during probe.

Johan