Re: [PATCH v2] ARM: bcm2835: add device tree for Raspberry Pi model B+

[Lee Jones <lee@kernel.org>]

> The model B and B+ differ in the GPIO lines for ACT and PWR leds, and the
> I2S interface.
> 
> Signed-off-by: Matthias Klein <matthias.klein@linux.com>
> ---
> Changes in v2:
> - move the common parts between the B and B+ model into the new bcm2835-rpi.dtsi file
> 
> - add the I2S signals to the B+ file which fix the problem that USB is not working
>   with the current bcm2835-rpi-b.dts file on the B+.
> ---
>  arch/arm/boot/dts/Makefile               |  1 +
>  arch/arm/boot/dts/bcm2835-rpi-b-plus.dts | 30 +++++++++++++++++++
>  arch/arm/boot/dts/bcm2835-rpi-b.dts      | 46 ++--------------------------
>  arch/arm/boot/dts/bcm2835-rpi.dtsi       | 51 ++++++++++++++++++++++++++++++++
>  4 files changed, 85 insertions(+), 43 deletions(-)
>  create mode 100644 arch/arm/boot/dts/bcm2835-rpi-b-plus.dts
>  create mode 100644 arch/arm/boot/dts/bcm2835-rpi.dtsi

Sorry for the delay.  I thought RPi world was exceptionally quiet, but
in fact I had issues with my newly setup mailbox and filters.  All
rectified now in any case.

It might be worth noting that this will not likely land in v3.19, as
we are one step removed from Linus (i.e. via ARM SoC) and they usually
like to have pull-requests in by -rc5.  Unless anyone stamps their
feet, I'll be sending this no sooner than v3.20.

Patch applied, thanks.

[...]