From: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
To: linux-kernel@vger.kernel.org
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
stable@vger.kernel.org, Songjun Wu <songjun.wu@atmel.com>,
Bo Shen <voice.shen@atmel.com>, Mark Brown <broonie@kernel.org>
Subject: [PATCH 3.18 31/39] ASoC: atmel_ssc_dai: fix start event for I2S mode
Date: Mon, 9 Feb 2015 16:34:14 +0800 [thread overview]
Message-ID: <20150209083330.247937583@linuxfoundation.org> (raw)
In-Reply-To: <20150209083328.753647350@linuxfoundation.org>
3.18-stable review patch. If anyone has any objections, please let me know.
------------------
From: Bo Shen <voice.shen@atmel.com>
commit a43bd7e125143b875caae6d4f9938855b440faaf upstream.
According to the I2S specification information as following:
- WS = 0, channel 1 (left)
- WS = 1, channel 2 (right)
So, the start event should be TF/RF falling edge.
Reported-by: Songjun Wu <songjun.wu@atmel.com>
Signed-off-by: Bo Shen <voice.shen@atmel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
sound/soc/atmel/atmel_ssc_dai.c | 18 ++++--------------
1 file changed, 4 insertions(+), 14 deletions(-)
--- a/sound/soc/atmel/atmel_ssc_dai.c
+++ b/sound/soc/atmel/atmel_ssc_dai.c
@@ -345,7 +345,6 @@ static int atmel_ssc_hw_params(struct sn
struct atmel_pcm_dma_params *dma_params;
int dir, channels, bits;
u32 tfmr, rfmr, tcmr, rcmr;
- int start_event;
int ret;
int fslen, fslen_ext;
@@ -454,19 +453,10 @@ static int atmel_ssc_hw_params(struct sn
* The SSC transmit clock is obtained from the BCLK signal on
* on the TK line, and the SSC receive clock is
* generated from the transmit clock.
- *
- * For single channel data, one sample is transferred
- * on the falling edge of the LRC clock.
- * For two channel data, one sample is
- * transferred on both edges of the LRC clock.
*/
- start_event = ((channels == 1)
- ? SSC_START_FALLING_RF
- : SSC_START_EDGE_RF);
-
rcmr = SSC_BF(RCMR_PERIOD, 0)
| SSC_BF(RCMR_STTDLY, START_DELAY)
- | SSC_BF(RCMR_START, start_event)
+ | SSC_BF(RCMR_START, SSC_START_FALLING_RF)
| SSC_BF(RCMR_CKI, SSC_CKI_RISING)
| SSC_BF(RCMR_CKO, SSC_CKO_NONE)
| SSC_BF(RCMR_CKS, ssc->clk_from_rk_pin ?
@@ -475,14 +465,14 @@ static int atmel_ssc_hw_params(struct sn
rfmr = SSC_BF(RFMR_FSEDGE, SSC_FSEDGE_POSITIVE)
| SSC_BF(RFMR_FSOS, SSC_FSOS_NONE)
| SSC_BF(RFMR_FSLEN, 0)
- | SSC_BF(RFMR_DATNB, 0)
+ | SSC_BF(RFMR_DATNB, (channels - 1))
| SSC_BIT(RFMR_MSBF)
| SSC_BF(RFMR_LOOP, 0)
| SSC_BF(RFMR_DATLEN, (bits - 1));
tcmr = SSC_BF(TCMR_PERIOD, 0)
| SSC_BF(TCMR_STTDLY, START_DELAY)
- | SSC_BF(TCMR_START, start_event)
+ | SSC_BF(TCMR_START, SSC_START_FALLING_RF)
| SSC_BF(TCMR_CKI, SSC_CKI_FALLING)
| SSC_BF(TCMR_CKO, SSC_CKO_NONE)
| SSC_BF(TCMR_CKS, ssc->clk_from_rk_pin ?
@@ -492,7 +482,7 @@ static int atmel_ssc_hw_params(struct sn
| SSC_BF(TFMR_FSDEN, 0)
| SSC_BF(TFMR_FSOS, SSC_FSOS_NONE)
| SSC_BF(TFMR_FSLEN, 0)
- | SSC_BF(TFMR_DATNB, 0)
+ | SSC_BF(TFMR_DATNB, (channels - 1))
| SSC_BIT(TFMR_MSBF)
| SSC_BF(TFMR_DATDEF, 0)
| SSC_BF(TFMR_DATLEN, (bits - 1));
next prev parent reply other threads:[~2015-02-09 8:37 UTC|newest]
Thread overview: 42+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-02-09 8:33 [PATCH 3.18 00/39] 3.18.7-stable review Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 01/39] gpio: sysfs: fix memory leak in gpiod_export_link Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 02/39] gpio: sysfs: fix memory leak in gpiod_sysfs_set_active_low Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 03/39] gpio: mcp23s08: handle default gpio base Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 04/39] PCI: designware: Reject MSI-X IRQs Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 05/39] PCI: Add NEC variants to Stratus ftServer PCIe DMI check Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 06/39] PCI: Handle read-only BARs on AMD CS553x devices Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 07/39] spi: spi-fsl-dspi: Remove usage of devm_kzalloc Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 08/39] spi: imx: use pio mode for i.mx6dl Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 09/39] sd: Fix max transfer length for 4k disks Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 10/39] MIPS: Fix C0_Pagegrain[IEC] support Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 11/39] MIPS: IRQ: Fix disable_irq on CPU IRQs Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 12/39] MIPS: OCTEON: fix kernel crash when offlining a CPU Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 13/39] MIPS: Fix kernel lockup or crash after CPU offline/online Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 14/39] MIPS: mipsregs.h: Add write_32bit_cp1_register() Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 15/39] MIPS: traps: Fix inline asm ctc1 missing .set hardfloat Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 16/39] ARM: 8299/1: mm: ensure local active ASID is marked as allocated on rollover Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 17/39] Complete oplock break jobs before closing file handle Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 18/39] md/raid5: fix another livelock caused by non-aligned writes Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 19/39] mm: pagewalk: call pte_hole() for VM_PFNMAP during walk_page_range Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 20/39] lib/checksum.c: fix carry in csum_tcpudp_nofold Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 21/39] memcg, shmem: fix shmem migration to use lrucare Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 22/39] nilfs2: fix deadlock of segment constructor over I_SYNC flag Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 23/39] drm/radeon: dont init gpuvm if accel is disabled (v3) Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 27/39] drm/radeon: properly set vm fragment size for TN/RL Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 29/39] arm64: Fix up /proc/cpuinfo Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 30/39] lib/checksum.c: fix build for generic csum_tcpudp_nofold Greg Kroah-Hartman
2015-02-09 8:34 ` Greg Kroah-Hartman [this message]
2015-02-09 8:34 ` [PATCH 3.18 32/39] ASoC: sgtl5000: add delay before first I2C access Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 33/39] ALSA: ak411x: Fix stall in work callback Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 34/39] ARM: dts: Fix I2S1, I2S2 compatible for exynos4 SoCs Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 35/39] x86, microcode: Return error from driver init code when loader is disabled Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 36/39] smpboot: Add missing get_online_cpus() in smpboot_register_percpu_thread() Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 37/39] hrtimer: Fix incorrect tai offset calculation for non high-res timer systems Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 38/39] tracing: Add condition check to RCU lockdep checks Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 39/39] x86/tlb/trace: Do not trace on CPU that is offline Greg Kroah-Hartman
2015-02-09 16:40 ` [PATCH 3.18 00/39] 3.18.7-stable review Guenter Roeck
2015-02-09 18:27 ` Shuah Khan
2015-02-09 21:37 ` Greg Kroah-Hartman
2015-02-09 22:03 ` Guenter Roeck
2015-02-09 22:24 ` Winkler, Tomas
2015-02-09 23:19 ` Shuah Khan
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20150209083330.247937583@linuxfoundation.org \
--to=gregkh@linuxfoundation.org \
--cc=broonie@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=songjun.wu@atmel.com \
--cc=stable@vger.kernel.org \
--cc=voice.shen@atmel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox