Re: [PATCH v2 3/3] power: wm831x_power: Support USB charger current limit management

[Peter Chen <peter.chen@freescale.com>]

On Mon, Aug 17, 2015 at 10:26:23AM -0700, Mark Brown wrote:
> On Mon, Aug 17, 2015 at 09:07:08AM +0800, Peter Chen wrote:
> > On Fri, Aug 14, 2015 at 05:47:46PM +0800, Baolin Wang wrote:
> 
> > > +	1500,
> > > +	1800,
> > > +	550,
> > > +};
> 
> > Why 550 is the last, but not 1800?
> 
> You'd have to ask the hardware engineers who designed the chip.  I
> suspect it's because 550 was added at a late stage in the design process
> but I'm basically just guessing there.

ok, I just had suspected below function's correctness, after looking
it again, it always set 1800 as charging limit, does it be expected?

+/* In miliamps */
+static unsigned int wm831x_usb_limits[] = {
+       0,
+       2,
+       100,
+       500,
+       900,
+       1500,
+       1800,
+       550,
+};
+
+static int wm831x_usb_limit_change(struct notifier_block *nb,
+                                  unsigned long limit, void *data)
+{
+       struct wm831x_power *wm831x_power = container_of(nb,
+                                                        struct wm831x_power,
+                                                        usb_notify);
+       int i, best;
+
+       /* Find the highest supported limit */
+       best = 0;
+       for (i = 0; i < ARRAY_SIZE(wm831x_usb_limits); i++) {
+               if (limit < wm831x_usb_limits[i] &&
+                   wm831x_usb_limits[best] < wm831x_usb_limits[i])
+                       best = i;
+       }
+
+       dev_dbg(wm831x_power->wm831x->dev,
+               "Limiting USB current to %dmA", wm831x_usb_limits[best]);
+
+       wm831x_set_bits(wm831x_power->wm831x, WM831X_POWER_STATE,
+                       WM831X_USB_ILIM_MASK, best);
+
+       return 0;
+}
+

> 
> > >   *********************************************************************/
> > > @@ -606,8 +646,31 @@ static int wm831x_power_probe(struct platform_device *pdev)
> > >  		}
> > >  	}
> 
> > > +	if (wm831x_pdata && wm831x_pdata->usb_gadget) {
> 
> > Where the wm831x_pdata->usb_gadget is initialized?
> 
> It's platform data, it will be initialised by whatever registers the
> platform data.

Get it, I just do not find in this patch set, thanks.

-- 

Best Regards,
Peter Chen