From: Rob Herring <robh@kernel.org>
To: Joshua Henderson <joshua.henderson@microchip.com>
Cc: linux-kernel@vger.kernel.org, linux-mips@linux-mips.org,
Purna Chandra Mandal <purna.mandal@microchip.com>,
Pawel Moll <pawel.moll@arm.com>,
Mark Rutland <mark.rutland@arm.com>,
Ian Campbell <ijc+devicetree@hellion.org.uk>,
Kumar Gala <galak@codeaurora.org>,
devicetree@vger.kernel.org
Subject: Re: [PATCH 03/14] DEVICETREE: Add PIC32 clock binding documentation
Date: Mon, 30 Nov 2015 15:43:44 -0600 [thread overview]
Message-ID: <20151130214344.GA13253@rob-hp-laptop> (raw)
In-Reply-To: <56569A77.8010800@microchip.com>
On Wed, Nov 25, 2015 at 10:36:55PM -0700, Joshua Henderson wrote:
> Hi Rob,
>
> On 11/22/2015 2:31 PM, Rob Herring wrote:
> > On Fri, Nov 20, 2015 at 05:17:15PM -0700, Joshua Henderson wrote:
> >> From: Purna Chandra Mandal <purna.mandal@microchip.com>
> >>
> >> Document the devicetree bindings for the clock driver found on Microchip
> >> PIC32 class devices.
> >>
> >> Signed-off-by: Purna Chandra Mandal <purna.mandal@microchip.com>
> >> Signed-off-by: Joshua Henderson <joshua.henderson@microchip.com>
> >> ---
> >> .../devicetree/bindings/clock/microchip,pic32.txt | 263 ++++++++++++++++++++
> >> 1 file changed, 263 insertions(+)
> >> create mode 100644 Documentation/devicetree/bindings/clock/microchip,pic32.txt
> >>
> >> diff --git a/Documentation/devicetree/bindings/clock/microchip,pic32.txt b/Documentation/devicetree/bindings/clock/microchip,pic32.txt
> >> new file mode 100644
> >> index 0000000..4cef72d
> >> --- /dev/null
> >> +++ b/Documentation/devicetree/bindings/clock/microchip,pic32.txt
> >> @@ -0,0 +1,263 @@
> >> +Binding for a Clock hardware block found on
> >> +certain Microchip PIC32 MCU devices.
> >> +
> >> +Microchip SoC clocks-node consists of few oscillators, PLL, multiplexer
> >> +and few divider nodes.
> >
> > [...]
> >
> >> +Required properties:
> >> +- compatible : should have "microchip,pic32-clk".
BTW, this should list out the actual compatible strings.
> > There is some discussion about this upstream with "critical-clocks"
> > binding. Can you use and wait for that?
> >
>
> The way this is going, we might not have to wait. :) Is there a patch available yet to try it out?
Yes, googling "Lee Jones critical-clocks" should find it.
> >> +- microchip,status-bit-mask: bitmask for status check. This will be used to confirm
> >> + particular operation by clock sub-node is completed. It is dependent sub-node.
> >> +- microchip,bit-mask: enable mask, similar to microchip,status-bit-mask.
> >
> > We've generally decided not to describe clocks at this level of detail
> > in DT. It's fine though for simple clock trees. This one seems to be
> > borderline IMO.
> >
>
> The binding example is the entire clock tree. These masks are right from the datasheet. For reference, do you have an example of a better alternative?
Okay, like I said, borderline. If this is complete, then it is fine.
Adding more clocks or a newer version of the SoC with more clocks would
change that opinion.
Rob
next prev parent reply other threads:[~2015-11-30 21:47 UTC|newest]
Thread overview: 45+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-11-21 0:17 [PATCH 00/14] Initial Microchip PIC32MZDA Support Joshua Henderson
2015-11-21 0:17 ` [PATCH 01/14] DEVICETREE: Add bindings for PIC32 interrupt controller Joshua Henderson
2015-11-21 20:47 ` Arnd Bergmann
2015-11-25 18:22 ` Joshua Henderson
2015-11-22 21:14 ` Rob Herring
2015-11-26 5:01 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 02/14] irqchip: irq-pic32-evic: Add support " Joshua Henderson
2015-11-22 11:45 ` Marc Zyngier
2015-11-25 18:22 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 03/14] DEVICETREE: Add PIC32 clock binding documentation Joshua Henderson
2015-11-21 20:49 ` Arnd Bergmann
2015-11-26 4:05 ` Joshua Henderson
2015-11-22 21:31 ` Rob Herring
2015-11-26 5:36 ` Joshua Henderson
2015-11-30 21:43 ` Rob Herring [this message]
2015-12-03 17:37 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 04/14] clk: clk-pic32: Add PIC32 clock driver Joshua Henderson
2015-11-21 0:17 ` [PATCH 05/14] DEVICETREE: Add bindings for PIC32/MZDA platforms Joshua Henderson
2015-11-22 21:35 ` Rob Herring
2015-11-21 0:17 ` [PATCH 06/14] MIPS: Add support for PIC32MZDA platform Joshua Henderson
2015-11-21 11:37 ` Alban
2015-11-22 16:29 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 07/14] DEVICETREE: Add bindings for PIC32 pin control and GPIO Joshua Henderson
2015-11-22 21:47 ` Rob Herring
2015-12-04 13:02 ` Andrei.Pistirica
2015-12-08 22:13 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 08/14] pinctrl: Add PIC32 pin control driver Joshua Henderson
2015-11-30 13:41 ` Linus Walleij
2015-12-08 22:15 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 09/14] DEVICETREE: Add bindings for PIC32 usart driver Joshua Henderson
2015-11-21 15:20 ` Sergei Shtylyov
2015-11-22 21:56 ` Rob Herring
2015-12-11 16:16 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 10/14] serial: pic32_uart: Add PIC32 uart driver Joshua Henderson
2015-11-21 0:17 ` [PATCH 11/14] mmc: sdhci-pic32: Add PIC32 SDHC host controller driver Joshua Henderson
2015-11-25 15:55 ` Ulf Hansson
2015-11-25 16:38 ` Ulf Hansson
2015-11-29 20:14 ` Paul.Thacker
2015-11-21 0:17 ` [PATCH 12/14] DEVICETREE: Add bindings for PIC32 SDHC host controller Joshua Henderson
2015-11-21 15:19 ` Sergei Shtylyov
2015-11-26 4:40 ` Joshua Henderson
2015-11-22 21:57 ` Rob Herring
2015-11-26 5:16 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 13/14] MIPS: dts: Add initial DTS for the PIC32MZDA Starter Kit Joshua Henderson
2015-11-21 0:17 ` [PATCH 14/14] MIPS: pic32mzda: Add initial PIC32MZDA Starter Kit defconfig Joshua Henderson
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20151130214344.GA13253@rob-hp-laptop \
--to=robh@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=galak@codeaurora.org \
--cc=ijc+devicetree@hellion.org.uk \
--cc=joshua.henderson@microchip.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mips@linux-mips.org \
--cc=mark.rutland@arm.com \
--cc=pawel.moll@arm.com \
--cc=purna.mandal@microchip.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox