[PATCH 5/7] drm/fsl-dcu: mask all interrupts on initialization

Stefan Agner
2015-11-19T02:43:12Z

The state of the interrupt mask register on initialization is
unknown, e.g. U-Boot could already used the DCU. So depending on
the boot loader, the outcome of the interrupt mask register could
be different. A defined state is much more preferable. Also, there
is no value in keeping interrupts enabled which we don't need.
Therefor, mask all interrupts on initialization.

Signed-off-by: Stefan Agner <stefan@agner.ch>
---
drivers/gpu/drm/fsl-dcu/fsl_dcu_drm_drv.c | 5 +----
1 file changed, 1 insertion(+), 4 deletions(-)

diff --git a/drivers/gpu/drm/fsl-dcu/fsl_dcu_drm_drv.c b/drivers/gpu/drm/fsl-dcu/fsl_dcu_drm_drv.c
index d37ff0e..e01c813 100644
--- a/drivers/gpu/drm/fsl-dcu/fsl_dcu_drm_drv.c
+++ b/drivers/gpu/drm/fsl-dcu/fsl_dcu_drm_drv.c
@@ -48,7 +48,6 @@ static const struct regmap_config fsl_dcu_regmap_config = {
static int fsl_dcu_drm_irq_init(struct drm_device *dev)
{
struct fsl_dcu_drm_device *fsl_dev = dev->dev_private;
- unsigned int value;
int ret;

ret = drm_irq_install(dev, fsl_dev->irq);
@@ -56,9 +55,7 @@ static int fsl_dcu_drm_irq_init(struct drm_device *dev)
dev_err(dev->dev, "failed to install IRQ handler\n");

regmap_write(fsl_dev->regmap, DCU_INT_STATUS, 0);
- regmap_read(fsl_dev->regmap, DCU_INT_MASK, &value);
- value &= DCU_INT_MASK_VBLANK;
- regmap_write(fsl_dev->regmap, DCU_INT_MASK, value);
+ regmap_write(fsl_dev->regmap, DCU_INT_MASK, ~0);
regmap_write(fsl_dev->regmap, DCU_UPDATE_MODE,
DCU_UPDATE_MODE_READREG);

--
2.6.2