Re: [PATCH 2/2] MIPS: CPS: Copy EVA configuration when starting secondary VPs.

[Paul Burton <paul.burton@imgtec.com>]

On Wed, May 18, 2016 at 03:45:22PM +0100, Matt Redfearn wrote:
> When starting secondary VPEs which support EVA and the SegCtl registers,
> copy the memory segmentation configuration from the running VPE to ensure
> that all VPEs in the core have a consitent virtual memory map.
> 
> The EVA configuration of secondary cores is dealt with when starting the
> core via the CM.
> 
> Signed-off-by: Matt Redfearn <matt.redfearn@imgtec.com>
> ---
> 
>  arch/mips/kernel/cps-vec.S | 16 ++++++++++++++++
>  1 file changed, 16 insertions(+)
> 
> diff --git a/arch/mips/kernel/cps-vec.S b/arch/mips/kernel/cps-vec.S
> index ac81edd44563..07b3274c8ae1 100644
> --- a/arch/mips/kernel/cps-vec.S
> +++ b/arch/mips/kernel/cps-vec.S
> @@ -431,6 +431,22 @@ LEAF(mips_cps_boot_vpes)
>  	mfc0	t0, CP0_CONFIG
>  	mttc0	t0, CP0_CONFIG
>  
> +	/* Copy the EVA config from this VPE if the CPU supports it */
> +	mfc0	t0, CP0_CONFIG, 1
> +	bgez	t0, 1f
> +	 mfc0	t0, CP0_CONFIG, 2
> +	bgez	t0, 1f
> +	 mfc0	t0, CP0_CONFIG, 3
> +	and	t0, t0, MIPS_CONF3_SC
> +	beqz	t0, 1f
> +	 nop

Hi Matt,

The checks here aren't *quite* right since they do the mfc0 of the next
register in the delay slot which will happen even if the M bit of the
preceeding register wasn't set. There are other cases in cps-vec.S where
I've made that mistake... Luckily, in this particular case, we know that
we have MT ASE support which means we know that Config3 exists. So I
think you can just remove the checks of Config1.M & Config2.M and just
read Config3 straight away.

Thanks,
    Paul

> +	mfc0    t0, CP0_SEGCTL0
> +	mttc0	t0, CP0_SEGCTL0
> +	mfc0    t0, CP0_SEGCTL1
> +	mttc0	t0, CP0_SEGCTL1
> +	mfc0    t0, CP0_SEGCTL2
> +	mttc0	t0, CP0_SEGCTL2
> +1:
>  	/* Ensure no software interrupts are pending */
>  	mttc0	zero, CP0_CAUSE
>  	mttc0	zero, CP0_STATUS
> -- 
> 2.5.0
>