[PATCH 4.6 059/100] usb: host: xhci-rcar: Avoid long wait in xhci_reset()

Greg Kroah-Hartman
2016-05-30T21:24:44Z

From: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>

commit f879fc32aa0c96fbac261b3d857a1239d554ad01 upstream.

The firmware of R-Car USB 3.0 host controller will control the reset.
So, if the xhci driver doesn't do firmware downloading (e.g. kernel
configuration is CONFIG_USB_XHCI_PLATFORM=y and CONFIG_USB_XHCI_RCAR
is not set), the reset of USB 3.0 host controller doesn't work
correctly. Then, the host controller will cause long wait in
xhci_reset() because the CMD_RESET bit of op_regs->command is not
cleared for 10 seconds.

So, this patch modifies the Kconfig to enable both CONFIG_USB_XHCI_PLATFORM
and CONFIG_USB_XHCI_RCAR.

Fixes: 4ac8918f3a7 (usb: host: xhci-plat: add support for the R-Car H2 and M2 xHCI controllers)
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Reviewed-by: Felipe Balbi <felipe.balbi@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

---
drivers/usb/host/Kconfig | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)

--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -35,6 +35,7 @@ config USB_XHCI_PCI

config USB_XHCI_PLATFORM
tristate "Generic xHCI driver for a platform device"
+ select USB_XHCI_RCAR if ARCH_RENESAS
---help---
Adds an xHCI host driver for a generic platform device, which
provides a memory space and an irq.
@@ -63,7 +64,7 @@ config USB_XHCI_MVEBU

config USB_XHCI_RCAR
tristate "xHCI support for Renesas R-Car SoCs"
- select USB_XHCI_PLATFORM
+ depends on USB_XHCI_PLATFORM
depends on ARCH_RENESAS || COMPILE_TEST
---help---
Say 'Y' to enable the support for the xHCI host controller