[PATCH 1/2] net: ethernet: ethoc: use phydev from struct net_device

[PATCH 1/2] net: ethernet: ethoc: use phydev from struct net_device

[Philippe Reynes]

The private structure contain a pointer to phydev, but the structure
net_device already contain such pointer. So we can remove the pointer
phy in the private structure, and update the driver to use the
one contained in struct net_device.

Signed-off-by: Philippe Reynes <tremyfr@gmail.com>
---
 drivers/net/ethernet/ethoc.c |   19 +++++++------------
 1 files changed, 7 insertions(+), 12 deletions(-)

diff --git a/drivers/net/ethernet/ethoc.c b/drivers/net/ethernet/ethoc.c
index 4edb98c..fe09021 100644
--- a/drivers/net/ethernet/ethoc.c
+++ b/drivers/net/ethernet/ethoc.c
@@ -219,7 +219,6 @@ struct ethoc {
 
 	spinlock_t lock;
 
-	struct phy_device *phy;
 	struct mii_bus *mdio;
 	struct clk *clk;
 	s8 phy_id;
@@ -694,7 +693,6 @@ static int ethoc_mdio_probe(struct net_device *dev)
 		return err;
 	}
 
-	priv->phy = phy;
 	phy->advertising &= ~(ADVERTISED_1000baseT_Full |
 			      ADVERTISED_1000baseT_Half);
 	phy->supported &= ~(SUPPORTED_1000baseT_Full |
@@ -724,7 +722,7 @@ static int ethoc_open(struct net_device *dev)
 		netif_start_queue(dev);
 	}
 
-	phy_start(priv->phy);
+	phy_start(dev->phydev);
 	napi_enable(&priv->napi);
 
 	if (netif_msg_ifup(priv)) {
@@ -741,8 +739,8 @@ static int ethoc_stop(struct net_device *dev)
 
 	napi_disable(&priv->napi);
 
-	if (priv->phy)
-		phy_stop(priv->phy);
+	if (dev->phydev)
+		phy_stop(dev->phydev);
 
 	ethoc_disable_rx_and_tx(priv);
 	free_irq(dev->irq, dev);
@@ -770,7 +768,7 @@ static int ethoc_ioctl(struct net_device *dev, struct ifreq *ifr, int cmd)
 		if (!phy)
 			return -ENODEV;
 	} else {
-		phy = priv->phy;
+		phy = dev->phydev;
 	}
 
 	return phy_mii_ioctl(phy, ifr, cmd);
@@ -899,8 +897,7 @@ out:
 
 static int ethoc_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
 {
-	struct ethoc *priv = netdev_priv(dev);
-	struct phy_device *phydev = priv->phy;
+	struct phy_device *phydev = dev->phydev;
 
 	if (!phydev)
 		return -EOPNOTSUPP;
@@ -910,8 +907,7 @@ static int ethoc_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
 
 static int ethoc_set_settings(struct net_device *dev, struct ethtool_cmd *cmd)
 {
-	struct ethoc *priv = netdev_priv(dev);
-	struct phy_device *phydev = priv->phy;
+	struct phy_device *phydev = dev->phydev;
 
 	if (!phydev)
 		return -EOPNOTSUPP;
@@ -1261,8 +1257,7 @@ static int ethoc_remove(struct platform_device *pdev)
 
 	if (netdev) {
 		netif_napi_del(&priv->napi);
-		phy_disconnect(priv->phy);
-		priv->phy = NULL;
+		phy_disconnect(netdev->phydev);
 
 		if (priv->mdio) {
 			mdiobus_unregister(priv->mdio);
-- 
1.7.4.4

[PATCH 2/2] net: ethernet: ethoc: use phy_ethtool_{get|set}_link_ksettings

[Philippe Reynes]

There are two generics functions phy_ethtool_{get|set}_link_ksettings,
so we can use them instead of defining the same code in the driver.

Signed-off-by: Philippe Reynes <tremyfr@gmail.com>
---
 drivers/net/ethernet/ethoc.c |   24 ++----------------------
 1 files changed, 2 insertions(+), 22 deletions(-)

diff --git a/drivers/net/ethernet/ethoc.c b/drivers/net/ethernet/ethoc.c
index fe09021..37fbf51 100644
--- a/drivers/net/ethernet/ethoc.c
+++ b/drivers/net/ethernet/ethoc.c
@@ -895,26 +895,6 @@ out:
 	return NETDEV_TX_OK;
 }
 
-static int ethoc_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
-{
-	struct phy_device *phydev = dev->phydev;
-
-	if (!phydev)
-		return -EOPNOTSUPP;
-
-	return phy_ethtool_gset(phydev, cmd);
-}
-
-static int ethoc_set_settings(struct net_device *dev, struct ethtool_cmd *cmd)
-{
-	struct phy_device *phydev = dev->phydev;
-
-	if (!phydev)
-		return -EOPNOTSUPP;
-
-	return phy_ethtool_sset(phydev, cmd);
-}
-
 static int ethoc_get_regs_len(struct net_device *netdev)
 {
 	return ETH_END;
@@ -979,14 +959,14 @@ static int ethoc_set_ringparam(struct net_device *dev,
 }
 
 const struct ethtool_ops ethoc_ethtool_ops = {
-	.get_settings = ethoc_get_settings,
-	.set_settings = ethoc_set_settings,
 	.get_regs_len = ethoc_get_regs_len,
 	.get_regs = ethoc_get_regs,
 	.get_link = ethtool_op_get_link,
 	.get_ringparam = ethoc_get_ringparam,
 	.set_ringparam = ethoc_set_ringparam,
 	.get_ts_info = ethtool_op_get_ts_info,
+	.get_link_ksettings = phy_ethtool_get_link_ksettings,
+	.set_link_ksettings = phy_ethtool_set_link_ksettings,
 };
 
 static const struct net_device_ops ethoc_netdev_ops = {
-- 
1.7.4.4

Re: [PATCH 2/2] net: ethernet: ethoc: use phy_ethtool_{get|set}_link_ksettings

[Tobias Klauser]

On 2016-06-25 at 16:33:42 +0200, Philippe Reynes <tremyfr@gmail.com> wrote:
> There are two generics functions phy_ethtool_{get|set}_link_ksettings,
> so we can use them instead of defining the same code in the driver.
> 
> Signed-off-by: Philippe Reynes <tremyfr@gmail.com>

Reviewed-by: Tobias Klauser <tklauser@distanz.ch>

Thanks

Re: [PATCH 1/2] net: ethernet: ethoc: use phydev from struct net_device

[Max Filippov]

On Sat, Jun 25, 2016 at 04:33:41PM +0200, Philippe Reynes wrote:
> The private structure contain a pointer to phydev, but the structure
> net_device already contain such pointer. So we can remove the pointer
> phy in the private structure, and update the driver to use the
> one contained in struct net_device.
> 
> Signed-off-by: Philippe Reynes <tremyfr@gmail.com>
> ---

Series:
Tested-by: Max Filippov <jcmvbkbc@gmail.com>

-- 
Thanks.
-- Max

Re: [PATCH 1/2] net: ethernet: ethoc: use phydev from struct net_device

[Tobias Klauser]

On 2016-06-25 at 16:33:41 +0200, Philippe Reynes <tremyfr@gmail.com> wrote:
> The private structure contain a pointer to phydev, but the structure
> net_device already contain such pointer. So we can remove the pointer
> phy in the private structure, and update the driver to use the
> one contained in struct net_device.

In that case the phy member should also be removed from the definition
of private struct ethoc in the same patch.

Otherwise the patch looks good to me.