Re: [PATCH 1/6] mfd: altera-a10sr: make it explicitly non-modular

Lee Jones
2016-08-31T11:41:39Z

On Tue, 23 Aug 2016, Paul Gortmaker wrote:

> On Fri, Aug 5, 2016 at 8:57 AM, Lee Jones <lee.jones@linaro.org> wrote:
> > On Mon, 04 Jul 2016, Paul Gortmaker wrote:
> >
> >> The Kconfig currently controlling compilation of this code is:
> >>
> >> drivers/mfd/Kconfig:config MFD_ALTERA_A10SR
> >> drivers/mfd/Kconfig: bool "Altera Arria10 DevKit System Resource chip"
> >>
> >> ...meaning that it currently is not being built as a module by anyone.
> >>
> >> Lets remove the modular code that is essentially orphaned, so that
> >> when reading the driver there is no doubt it is builtin-only.
> >>
>
> [...]
>
> >>
> >> Cc: Thor Thayer <tthayer@opensource.altera.com>
> >> Cc: Lee Jones <lee.jones@linaro.org>
> >> Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
> >> ---
> >> drivers/mfd/altera-a10sr.c | 14 ++++++--------
> >> 1 file changed, 6 insertions(+), 8 deletions(-)
> >
> > Applied, thanks.
>
> Hi Lee,
>
> I never did see this applied copy of the patch loop around via linux-next
> and conflict with my local copy of the same patch. Same for 3,4,5,6 of
> the same series (patch #2 was not applied; it was dropped in favour of
> a redo as a tristate conversion.)
>
> Just wanting to double check I didn't mess something up that caused them
> to get silently dropped after the fact, before I prepare to send any additional
> mfd patches to be considered for your 4.9 content queue.

It's been dropped. Make your subsequent changes.

--
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog