From: Kishon Vijay Abraham I <kishon@ti.com>
To: <gregkh@linuxfoundation.org>
Cc: <kishon@ti.com>, <linux-kernel@vger.kernel.org>
Subject: [PATCH 08/32] phy: meson8b-usb2: fix offsets for some of the registers
Date: Mon, 10 Apr 2017 18:47:59 +0530 [thread overview]
Message-ID: <20170410131823.26485-9-kishon@ti.com> (raw)
In-Reply-To: <20170410131823.26485-1-kishon@ti.com>
From: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
The register offsets for REG_DBG_UART (and all following) were off by
0x4. This was not a problem yet because these registers are currently
not used by the driver.
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Reviewed-by: Jerome Brunet <jbrunet@baylibre.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
---
drivers/phy/phy-meson8b-usb2.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/phy/phy-meson8b-usb2.c b/drivers/phy/phy-meson8b-usb2.c
index 33c9f4ba157d..30f56a6a411f 100644
--- a/drivers/phy/phy-meson8b-usb2.c
+++ b/drivers/phy/phy-meson8b-usb2.c
@@ -81,9 +81,9 @@
#define REG_ADP_BC_ACA_PIN_GND BIT(25)
#define REG_ADP_BC_ACA_PIN_FLOAT BIT(26)
-#define REG_DBG_UART 0x14
+#define REG_DBG_UART 0x10
-#define REG_TEST 0x18
+#define REG_TEST 0x14
#define REG_TEST_DATA_IN_MASK GENMASK(3, 0)
#define REG_TEST_EN_MASK GENMASK(7, 4)
#define REG_TEST_ADDR_MASK GENMASK(11, 8)
@@ -93,7 +93,7 @@
#define REG_TEST_DATA_OUT_MASK GENMASK(19, 16)
#define REG_TEST_DISABLE_ID_PULLUP BIT(20)
-#define REG_TUNE 0x1c
+#define REG_TUNE 0x18
#define REG_TUNE_TX_RES_TUNE_MASK GENMASK(1, 0)
#define REG_TUNE_TX_HSXV_TUNE_MASK GENMASK(3, 2)
#define REG_TUNE_TX_VREF_TUNE_MASK GENMASK(7, 4)
--
2.11.0
next prev parent reply other threads:[~2017-04-10 13:18 UTC|newest]
Thread overview: 40+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-04-10 13:17 [GIT PULL] phy: for 4.12 Kishon Vijay Abraham I
2017-04-10 13:17 ` [PATCH 01/32] mfd: exynos-lpass: Use common soc/exynos-regs-pmu.h header Kishon Vijay Abraham I
2017-04-11 14:14 ` Lee Jones
2017-04-11 14:20 ` Greg KH
2017-04-11 14:24 ` Kishon Vijay Abraham I
2017-04-11 16:34 ` Lee Jones
2017-04-12 5:19 ` Kishon Vijay Abraham I
2017-04-12 7:57 ` Lee Jones
2017-04-10 13:17 ` [PATCH 02/32] phy: phy-exynos-pcie: make it explicitly non-modular Kishon Vijay Abraham I
2017-04-10 13:17 ` [PATCH 03/32] mfd: exynos-lpass: Use common soc/exynos-regs-pmu.h header Kishon Vijay Abraham I
2017-04-10 13:17 ` [PATCH 04/32] dt: bindings: add pmu0 regs for USB PHYs on Allwinner H3/V3s/A64 Kishon Vijay Abraham I
2017-04-10 13:17 ` [PATCH 05/32] phy: sun4i-usb: change PHYCTL register clearing code Kishon Vijay Abraham I
2017-04-10 13:17 ` [PATCH 06/32] phy: sun4i-usb: add PHYCTL offset for H3 SoC Kishon Vijay Abraham I
2017-04-10 13:17 ` [PATCH 07/32] phy: sun4i-usb: support automatically switch PHY0 route to MUSB/HCI Kishon Vijay Abraham I
2017-04-10 13:17 ` Kishon Vijay Abraham I [this message]
2017-04-10 13:18 ` [PATCH 09/32] phy: exynos4: Remove duplicated defines of PHY register defines Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 10/32] phy: exynos5: " Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 11/32] phy: exynos-mipi-video: Use consistent method to address phy registers Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 12/32] phy: exynos: Use one define for enable bit Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 13/32] phy: rockchip-inno-usb2: fix spelling mistake: "connecetd" -> "connected" Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 14/32] phy: rcar-gen3-usb2: fix implementation for runtime PM Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 15/32] phy: sun4i-usb: enable PHY0 dual route switching for A64 USB PHY Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 16/32] phy: phy-mt65xx-usb3: improve RX detection stable time Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 17/32] phy: phy-mt65xx-usb3: increase LFPS filter threshold Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 18/32] phy: phy-mt65xx-usb3: split SuperSpeed port into two ones Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 19/32] phy: phy-mt65xx-usb3: move clock from phy node into port nodes Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 20/32] phy: phy-mt65xx-usb3: add support for new version phy Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 21/32] phy: phy-mt65xx-usb3: disable 100uA extraction from SS port to HS port Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 22/32] dt-bindings: phy-mt65xx-usb: add support for new version phy Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 23/32] dt-bindings: phy-rockchip-inno-usb2: add assign clock property in usb2-phy node Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 24/32] dt-bindings: add DT bindings for usb2-phy grf Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 25/32] phy: rockchip-inno-usb2: add support of usb2-phy for rk3328 Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 26/32] dt-bindings: phy: Add support for QUSB2 phy Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 27/32] phy: qcom-qusb2: New driver for QUSB2 PHY on Qcom chips Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 28/32] dt-bindings: phy: Add support for QMP phy Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 29/32] phy: qcom-qmp: new qmp phy driver for qcom-chipsets Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 30/32] phy: bcm-ns-usb3: split all writes into reg & val pairs Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 31/32] phy: rockchip-usb: Add vbus regulator support Kishon Vijay Abraham I
2017-04-10 13:18 ` [PATCH 32/32] phy: qcom-qusb2: add NVMEM dependency Kishon Vijay Abraham I
2017-04-10 13:46 ` [GIT PULL] phy: for 4.12 Greg KH
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20170410131823.26485-9-kishon@ti.com \
--to=kishon@ti.com \
--cc=gregkh@linuxfoundation.org \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox