[PATCH 0/8] RPi touchscreen panel driver v4

[Eric Anholt <eric@anholt.net>]

The review for v3 was basically "no, the panel should probe first so
that we have the connector by the time KMS is done initializing."  To
do this, I needed to be able to register the custom (non-OF-generated)
DSI device without the host being present (patch 6).  Also check out
patch 4 for a new cleanup to panel-bridge.

Eric Anholt (8):
  drm/vc4: Fix DSI T_INIT timing.
  drm/vc4: Fix misleading name of the continuous flag.
  drm/vc4: Use drm_mode_vrefresh() in DSI fixup, in case vrefresh is 0.
  drm/bridge: Add a devm_ allocator for panel bridge.
  drm/vc4: Delay DSI host registration until the panel has probed.
  drm: Allow DSI devices to be registered before the host registers.
  dt-bindings: Document the Raspberry Pi Touchscreen nodes.
  drm/panel: Add support for the Raspberry Pi 7" Touchscreen.

 .../panel/raspberrypi,7inch-touchscreen.txt        |  49 ++
 drivers/gpu/drm/bridge/panel.c                     |  30 ++
 drivers/gpu/drm/drm_mipi_dsi.c                     |  49 +-
 drivers/gpu/drm/panel/Kconfig                      |   8 +
 drivers/gpu/drm/panel/Makefile                     |   1 +
 .../gpu/drm/panel/panel-raspberrypi-touchscreen.c  | 505 +++++++++++++++++++++
 drivers/gpu/drm/vc4/vc4_dsi.c                      |  64 +--
 include/drm/drm_bridge.h                           |   3 +
 include/drm/drm_mipi_dsi.h                         |   3 +
 9 files changed, 671 insertions(+), 41 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/display/panel/raspberrypi,7inch-touchscreen.txt
 create mode 100644 drivers/gpu/drm/panel/panel-raspberrypi-touchscreen.c

-- 
2.11.0