Re: [PATCH v3 3/5] pwm-backlight: add support for PWM delays proprieties.

[Pavel Machek <pavel@ucw.cz>]

[-- Attachment #1: Type: text/plain, Size: 1652 bytes --]

On Thu 2017-07-20 11:37:17, Daniel Thompson wrote:
> On 20/07/17 09:06, Pavel Machek wrote:
> >Hi!
> >
> >>>--- a/drivers/video/backlight/pwm_bl.c
> >>>+++ b/drivers/video/backlight/pwm_bl.c
> >>>@@ -10,6 +10,7 @@
> >>>   * published by the Free Software Foundation.
> >>>   */
> >>>+#include <linux/delay.h>
> >>>  #include <linux/gpio/consumer.h>
> >>>  #include <linux/gpio.h>
> >>>  #include <linux/module.h>
> >>>@@ -35,6 +36,7 @@ struct pwm_bl_data {
> >>>  	struct gpio_desc	*enable_gpio;
> >>>  	unsigned int		scale;
> >>>  	bool			legacy;
> >>>+	unsigned int		pwm_delay[2];
> >>
> >>Two named members would be better here (eliminating the "magic" 0
> >>and 1).
> >
> >My thought, too.
> >
> >>>@@ -56,6 +58,9 @@ static void pwm_backlight_power_on(struct pwm_bl_data *pb, int brightness)
> >>>  	pwm_enable(pb->pwm);
> >>>+	if (pb->pwm_delay[0])
> >>>+		usleep_range(pb->pwm_delay[0], pb->pwm_delay[0] * 2);
> >
> >Plus I'd just do the delay unconditionally :-).
> 
> ... does this still apply if this code is switched to msleep()?

No.

> msleep() has no wait avoidance[1] and if lots of drivers are reckless about
> sleeping for 10ms it soon starts to show up in the boot time (especially
> optimized ones).
...
> [1] As it happens I can't see that many early bail out paths in
>     usleep_range() either.

Well, in usleep_range(1,2) should be fast enough operation, and
usleep_range(0,0) should be similar to usleep_range(1,2) at worst :-).
									Pavel
-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html

[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 181 bytes --]