[PATCH 4.16 135/272] watchdog: aspeed: Allow configuring for alternate boot

Greg Kroah-Hartman
2018-05-28T11:49:29Z

From: Milton Miller <miltonm@us.ibm.com>

[ Upstream commit 6ffa3402211acc30e47e691e14d62f3fd065a54e ]

Allow the device tree to specify a watchdog to fallover to
the alternate boot source.

The aspeeed watchdog can set a latch directing flash chip select 0 to
chip select 1, allowing boot from an alternate media if the watchdog
is not reset in time. On the ast2400 bank 1 also goes to flash bank 1,
while on the ast2500 the chip selects are swapped.

Also clear the secondary boot bit during the machine restart operation.
Otherwise, the system will switch to the alternate boot after every
reboot, which is not desired.

Signed-off-by: Milton Miller <miltonm@us.ibm.com>
Signed-off-by: Eddie James <eajames@linux.vnet.ibm.com>
Reviewed-by: Joel Stanley <joel@jms.id.au>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>
Signed-off-by: Sasha Levin <alexander.levin@microsoft.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
drivers/watchdog/aspeed_wdt.c | 4 ++++
1 file changed, 4 insertions(+)

--- a/drivers/watchdog/aspeed_wdt.c
+++ b/drivers/watchdog/aspeed_wdt.c
@@ -46,6 +46,7 @@ MODULE_DEVICE_TABLE(of, aspeed_wdt_of_ta
#define WDT_RELOAD_VALUE 0x04
#define WDT_RESTART 0x08
#define WDT_CTRL 0x0C
+#define WDT_CTRL_BOOT_SECONDARY BIT(7)
#define WDT_CTRL_RESET_MODE_SOC (0x00 << 5)
#define WDT_CTRL_RESET_MODE_FULL_CHIP (0x01 << 5)
#define WDT_CTRL_RESET_MODE_ARM_CPU (0x10 << 5)
@@ -158,6 +159,7 @@ static int aspeed_wdt_restart(struct wat
{
struct aspeed_wdt *wdt = to_aspeed_wdt(wdd);

+ wdt->ctrl &= ~WDT_CTRL_BOOT_SECONDARY;
aspeed_wdt_enable(wdt, 128 * WDT_RATE_1MHZ / 1000);

mdelay(1000);
@@ -242,6 +244,8 @@ static int aspeed_wdt_probe(struct platf
}
if (of_property_read_bool(np, "aspeed,external-signal"))
wdt->ctrl |= WDT_CTRL_WDT_EXT;
+ if (of_property_read_bool(np, "aspeed,alt-boot"))
+ wdt->ctrl |= WDT_CTRL_BOOT_SECONDARY;

if (readl(wdt->base + WDT_CTRL) & WDT_CTRL_ENABLE) {
/*