[PATCH v3 4/9] dt-bindings: display: add DT bindings for BOE HV070WSA-100 panel

Maciej Purski
2018-06-19T08:22:13Z

From: Andrzej Hajda <a.hajda@samsung.com>

The patch adds bindings to BOE HV070-WSA WSVGA panel.
Bindings are compatible with simple panel bindings.

Signed-off-by: Andrzej Hajda <a.hajda@samsung.com>
Signed-off-by: Maciej Purski <m.purski@samsung.com>
---
.../bindings/display/panel/boe,hv070wsa-100.txt | 28 ++++++++++++++++++++++
1 file changed, 28 insertions(+)
create mode 100644 Documentation/devicetree/bindings/display/panel/boe,hv070wsa-100.txt

diff --git a/Documentation/devicetree/bindings/display/panel/boe,hv070wsa-100.txt b/Documentation/devicetree/bindings/display/panel/boe,hv070wsa-100.txt
new file mode 100644
index 0000000..9e8eea8
--- /dev/null
+++ b/Documentation/devicetree/bindings/display/panel/boe,hv070wsa-100.txt
@@ -0,0 +1,28 @@
+BOE HV070WSA-100 7.01" WSVGA TFT LCD panel
+
+Required properties:
+- compatible: should be "boe,hv070wsa-100"
+- power-supply: regulator to provide the VCC supply voltage (3.3 volts)
+- enable-gpio: GPIO pin to enable and disable panel (active high)
+
+This binding is compatible with the simple-panel binding, which is specified
+in simple-panel.txt in this directory.
+
+The device node can contain one 'port' child node with one child
+'endpoint' node, according to the bindings defined in [1]. This
+node should describe panel's video bus.
+
+[1]: Documentation/devicetree/bindings/media/video-interfaces.txt
+
+Example:
+
+ panel: panel {
+ compatible = "boe,hv070wsa-100";
+ power-supply = <&vcc_3v3_reg>;
+ enable-gpios = <&gpd1 3 GPIO_ACTIVE_HIGH>;
+ port {
+ panel_ep: endpoint {
+ remote-endpoint = <&bridge_out_ep>;
+ };
+ };
+ };
--
2.7.4