Re: [PATCH] Add support of TI ICDI to USB simple serial device

Greg KH
2018-10-18T16:53:09Z

On Sat, Oct 13, 2018 at 05:10:50PM +0800, Da Shi Cao wrote:
> In-Circuit Debug Interface is a debugging interface for TI ARM
> microcontrollers. It has three USB interfaces and two of them are
> presented as standard ACM serial device. The 3rd interface is the
> debugging interface and it can be driven as a Linux USB simple
> terminal. With it, debugging session and firmware up/down loading are
> supported on Linux.
>
> Signed-off-by: Dashi Cao <dscao999@hotmail.com, dscao999@gmail.com>
> ---
> drivers/usb/serial/usb-serial-simple.c | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/drivers/usb/serial/usb-serial-simple.c
> b/drivers/usb/serial/usb-serial-simple.c
> index 4d0273508043..ae43088b659e 100644
> --- a/drivers/usb/serial/usb-serial-simple.c
> +++ b/drivers/usb/serial/usb-serial-simple.c
> @@ -109,6 +109,11 @@ DEVICE(suunto, SUUNTO_IDS);
> { USB_DEVICE(0x908, 0x0004) }
> DEVICE(siemens_mpi, SIEMENS_IDS);
>
> +/* TI In-Circuit Debug Interface */
> +#define ICDI_IDS() \
> + { USB_DEVICE_INTERFACE_CLASS(0x1cbe, 0x00fd, USB_CLASS_VENDOR_SPEC) }
> +DEVICE(ti_icdi, ICDI_IDS);
> +
> /* All of the above structures mushed into two lists */
> static struct usb_serial_driver * const serial_drivers[] = {
> &carelink_device,
> @@ -124,6 +129,7 @@ static struct usb_serial_driver * const serial_drivers[] = {
> &hp4x_device,
> &suunto_device,
> &siemens_mpi_device,
> + &ti_icdi_device,
> NULL
> };
>
> @@ -141,6 +147,7 @@ static const struct usb_device_id id_table[] = {
> HP4X_IDS(),
> SUUNTO_IDS(),
> SIEMENS_IDS(),
> + ICDI_IDS(),
> { },
> };
> MODULE_DEVICE_TABLE(usb, id_table);
> --
> 2.11.0

Hi,

This is the friendly patch-bot of Greg Kroah-Hartman. You have sent him
a patch that has triggered this response. He used to manually respond
to these common problems, but in order to save his sanity (he kept
writing the same thing over and over, yet to different people), I was
created. Hopefully you will not take offence and will fix the problem
in your patch and resubmit it so that it can be accepted into the Linux
kernel tree.

You are receiving this message because of the following common error(s)
as indicated below:

- Your patch is malformed (tabs converted to spaces, linewrapped, etc.)
and can not be applied. Please read the file,
Documentation/email-clients.txt in order to fix this.

If you wish to discuss this problem further, or you have questions about
how to resolve this issue, please feel free to respond to this email and
Greg will reply once he has dug out from the pending patches received
from other developers.

thanks,

greg k-h's patch email bot