Re: [PATCH v2] net: stmmac: Move debugfs init/exit to ->probe()/->remove()

Jose Abreu
2018-11-28T09:38:39Z

On 27-11-2018 13:21, Thierry Reding wrote:
> From: Thierry Reding <treding@nvidia.com>
>
> Setting up and tearing down debugfs is current unbalanced, as seen by
> this error during resume from suspend:
>
> [ 752.134067] dwc-eth-dwmac 2490000.ethernet eth0: ERROR failed to create debugfs directory
> [ 752.134347] dwc-eth-dwmac 2490000.ethernet eth0: stmmac_hw_setup: failed debugFS registration
>
> The imbalance happens because the driver creates the debugfs hierarchy
> when the device is opened and tears it down when the device is closed.
> There's little gain in that, and it could be argued that it is even
> surprising because it's not usually done for other devices. Fix the
> imbalance by moving the debugfs creation and teardown to the driver's
> ->probe() and ->remove() implementations instead.
>
> Note that the ring descriptors cannot be read while the interface is
> down, so make sure to return an empty file when the descriptors_status
> debugfs file is read.
>
> Signed-off-by: Thierry Reding <treding@nvidia.com>
> ---
> This applies on top of net-next.
>
> Changes in v2:
> - avoid access to ring descriptors when interface is down
>
> .../net/ethernet/stmicro/stmmac/stmmac_main.c | 23 +++++++++++--------
> 1 file changed, 13 insertions(+), 10 deletions(-)
>
> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> index 076a8be18d67..5551fead8f66 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> @@ -2550,12 +2550,6 @@ static int stmmac_hw_setup(struct net_device *dev, bool init_ptp)
> netdev_warn(priv->dev, "PTP init failed\n");
> }
>
> -#ifdef CONFIG_DEBUG_FS
> - ret = stmmac_init_fs(dev);
> - if (ret < 0)
> - netdev_warn(priv->dev, "%s: failed debugFS registration\n",
> - __func__);
> -#endif
> priv->tx_lpi_timer = STMMAC_DEFAULT_TWT_LS;
>
> if (priv->use_riwt) {
> @@ -2756,10 +2750,6 @@ static int stmmac_release(struct net_device *dev)
>
> netif_carrier_off(dev);
>
> -#ifdef CONFIG_DEBUG_FS
> - stmmac_exit_fs(dev);
> -#endif
> -
> stmmac_release_ptp(priv);
>
> return 0;
> @@ -3899,6 +3889,9 @@ static int stmmac_sysfs_ring_read(struct seq_file *seq, void *v)
> u32 tx_count = priv->plat->tx_queues_to_use;
> u32 queue;
>
> + if ((dev->flags & IFF_UP) == 0)

I tried looking for an helper to check if interface is open but
couldn't find one so I guess this is the right thing to do.

Acked-by: Jose Abreu <joabreu@synopsys.com>

Thanks and Best Regards,
Jose Miguel Abreu

> + return 0;
> +
> for (queue = 0; queue < rx_count; queue++) {
> struct stmmac_rx_queue *rx_q = &priv->rx_queue[queue];
>
> @@ -4397,6 +4390,13 @@ int stmmac_dvr_probe(struct device *device,
> goto error_netdev_register;
> }
>
> +#ifdef CONFIG_DEBUG_FS
> + ret = stmmac_init_fs(ndev);
> + if (ret < 0)
> + netdev_warn(priv->dev, "%s: failed debugFS registration\n",
> + __func__);
> +#endif
> +
> return ret;
>
> error_netdev_register:
> @@ -4432,6 +4432,9 @@ int stmmac_dvr_remove(struct device *dev)
>
> netdev_info(priv->dev, "%s: removing driver", __func__);
>
> +#ifdef CONFIG_DEBUG_FS
> + stmmac_exit_fs(ndev);
> +#endif
> stmmac_stop_all_dma(priv);
>
> stmmac_mac_set(priv, priv->ioaddr, false);