From: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
To: linux-kernel@vger.kernel.org
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
stable@vger.kernel.org, Lukas Wunner <lukas@wunner.de>,
Frank Pavlic <f.pavlic@kunbus.de>,
Ben Dooks <ben.dooks@codethink.co.uk>,
Tristram Ha <Tristram.Ha@microchip.com>,
"David S. Miller" <davem@davemloft.net>,
"Sasha Levin (Microsoft)" <sashal@kernel.org>
Subject: [PATCH 4.9 17/32] net: ks8851: Delay requesting IRQ until opened
Date: Thu, 2 May 2019 17:21:03 +0200 [thread overview]
Message-ID: <20190502143320.148720624@linuxfoundation.org> (raw)
In-Reply-To: <20190502143314.649935114@linuxfoundation.org>
[ Upstream commit d268f31552794abf5b6aa5af31021643411f25f5 ]
The ks8851 driver currently requests the IRQ before registering the
net_device. Because the net_device name is used as IRQ name and is
still "eth%d" when the IRQ is requested, it's impossibe to tell IRQs
apart if multiple ks8851 chips are present. Most other drivers delay
requesting the IRQ until the net_device is opened. Do the same.
The driver doesn't enable interrupts on the chip before opening the
net_device and disables them when closing it, so there doesn't seem to
be a need to request the IRQ already on probe.
Signed-off-by: Lukas Wunner <lukas@wunner.de>
Cc: Frank Pavlic <f.pavlic@kunbus.de>
Cc: Ben Dooks <ben.dooks@codethink.co.uk>
Cc: Tristram Ha <Tristram.Ha@microchip.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Sasha Levin (Microsoft) <sashal@kernel.org>
---
drivers/net/ethernet/micrel/ks8851.c | 24 +++++++++++-------------
1 file changed, 11 insertions(+), 13 deletions(-)
diff --git a/drivers/net/ethernet/micrel/ks8851.c b/drivers/net/ethernet/micrel/ks8851.c
index a8c5641ff955..ff6cab4f6343 100644
--- a/drivers/net/ethernet/micrel/ks8851.c
+++ b/drivers/net/ethernet/micrel/ks8851.c
@@ -797,6 +797,15 @@ static void ks8851_tx_work(struct work_struct *work)
static int ks8851_net_open(struct net_device *dev)
{
struct ks8851_net *ks = netdev_priv(dev);
+ int ret;
+
+ ret = request_threaded_irq(dev->irq, NULL, ks8851_irq,
+ IRQF_TRIGGER_LOW | IRQF_ONESHOT,
+ dev->name, ks);
+ if (ret < 0) {
+ netdev_err(dev, "failed to get irq\n");
+ return ret;
+ }
/* lock the card, even if we may not actually be doing anything
* else at the moment */
@@ -911,6 +920,8 @@ static int ks8851_net_stop(struct net_device *dev)
dev_kfree_skb(txb);
}
+ free_irq(dev->irq, ks);
+
return 0;
}
@@ -1542,14 +1553,6 @@ static int ks8851_probe(struct spi_device *spi)
ks8851_read_selftest(ks);
ks8851_init_mac(ks);
- ret = request_threaded_irq(spi->irq, NULL, ks8851_irq,
- IRQF_TRIGGER_LOW | IRQF_ONESHOT,
- ndev->name, ks);
- if (ret < 0) {
- dev_err(&spi->dev, "failed to get irq\n");
- goto err_irq;
- }
-
ret = register_netdev(ndev);
if (ret) {
dev_err(&spi->dev, "failed to register network device\n");
@@ -1562,11 +1565,7 @@ static int ks8851_probe(struct spi_device *spi)
return 0;
-
err_netdev:
- free_irq(ndev->irq, ks);
-
-err_irq:
err_id:
if (gpio_is_valid(gpio))
gpio_set_value(gpio, 0);
@@ -1587,7 +1586,6 @@ static int ks8851_remove(struct spi_device *spi)
dev_info(&spi->dev, "remove\n");
unregister_netdev(priv->netdev);
- free_irq(spi->irq, priv);
if (gpio_is_valid(priv->gpio))
gpio_set_value(priv->gpio, 0);
regulator_disable(priv->vdd_reg);
--
2.19.1
next prev parent reply other threads:[~2019-05-02 15:48 UTC|newest]
Thread overview: 38+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-05-02 15:20 [PATCH 4.9 00/32] 4.9.173-stable review Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 01/32] usbnet: ipheth: prevent TX queue timeouts when device not ready Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 02/32] usbnet: ipheth: fix potential null pointer dereference in ipheth_carrier_set Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 03/32] media: vivid: check if the cec_adapter is valid Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 04/32] ARM: dts: bcm283x: Fix hdmi hpd gpio pull Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 05/32] s390: limit brk randomization to 32MB Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 06/32] qlcnic: Avoid potential NULL pointer dereference Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 07/32] netfilter: nft_set_rbtree: check for inactive element after flag mismatch Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 08/32] netfilter: bridge: set skb transport_header before entering NF_INET_PRE_ROUTING Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 09/32] sc16is7xx: missing unregister/delete driver on error in sc16is7xx_init() Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 10/32] serial: ar933x_uart: Fix build failure with disabled console Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 11/32] usb: gadget: net2280: Fix overrun of OUT messages Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 12/32] usb: gadget: net2280: Fix net2280_dequeue() Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 13/32] usb: gadget: net2272: Fix net2272_dequeue() Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 14/32] ARM: dts: pfla02: increase phy reset duration Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 15/32] net: ks8851: Dequeue RX packets explicitly Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 16/32] net: ks8851: Reassert reset pin if chip ID check fails Greg Kroah-Hartman
2019-05-02 15:21 ` Greg Kroah-Hartman [this message]
2019-05-02 15:21 ` [PATCH 4.9 18/32] net: ks8851: Set initial carrier state to down Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 19/32] staging: rtl8712: uninitialized memory in read_bbreg_hdl() Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 20/32] NFS: Fix a typo in nfs_init_timeout_values() Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 21/32] net: xilinx: fix possible object reference leak Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 22/32] net: ibm: " Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 23/32] net: ethernet: ti: " Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 24/32] scsi: qla4xxx: fix a potential NULL pointer dereference Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 25/32] usb: u132-hcd: fix resource leak Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 26/32] ceph: fix use-after-free on symlink traversal Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 27/32] scsi: zfcp: reduce flood of fcrscn1 trace records on multi-element RSCN Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 28/32] libata: fix using DMA buffers on stack Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 29/32] gpio: of: Fix of_gpiochip_add() error path Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 30/32] kconfig/[mn]conf: handle backspace (^H) key Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 31/32] leds: pca9532: fix a potential NULL pointer dereference Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 32/32] vfio/type1: Limit DMA mappings per container Greg Kroah-Hartman
2019-05-02 23:06 ` [PATCH 4.9 00/32] 4.9.173-stable review kernelci.org bot
2019-05-03 7:04 ` Naresh Kamboju
2019-05-03 9:27 ` Jon Hunter
2019-05-03 17:15 ` Guenter Roeck
2019-05-03 21:21 ` shuah
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20190502143320.148720624@linuxfoundation.org \
--to=gregkh@linuxfoundation.org \
--cc=Tristram.Ha@microchip.com \
--cc=ben.dooks@codethink.co.uk \
--cc=davem@davemloft.net \
--cc=f.pavlic@kunbus.de \
--cc=linux-kernel@vger.kernel.org \
--cc=lukas@wunner.de \
--cc=sashal@kernel.org \
--cc=stable@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox