[PATCH v5 3/3] arm64: dts: allwinner: a64-oceanic-5205-5inmfd: Enable GT911 CTP

[Jagan Teki <jagan@amarulasolutions.com>]

Goodix GT911 CTP is bound with Oceanic 5205 5inMFD board.

The CTP connected to board with,
- SDA, SCK from i2c0
- GPIO-LD0 as AVDD28 supply
- PH4 gpio as interrupt pin
- PH11 gpio as reset pin
- X axis is inverted
- Y axis is inverted

Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
---
Changes for v5:
- none
Changes for v4:
- drop i2c1 pinctrl
Changes for v3:
- Use 2.8v for reg_ldo_io0
Changes for v2:
- drop i2c1, bias-pull-up


 .../sun50i-a64-oceanic-5205-5inmfd.dts        | 23 +++++++++++++++++++
 1 file changed, 23 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-oceanic-5205-5inmfd.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-oceanic-5205-5inmfd.dts
index 6a2154525d1e..787ebd805a3b 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-oceanic-5205-5inmfd.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-oceanic-5205-5inmfd.dts
@@ -37,6 +37,22 @@
 	status = "okay";
 };
 
+&i2c0 {
+	status = "okay";
+
+	touchscreen@5d {
+		compatible = "goodix,gt911";
+		reg = <0x5d>;
+		AVDD28-supply = <&reg_ldo_io0>;			/* VDD_CTP: GPIO0-LDO */
+		interrupt-parent = <&pio>;
+		interrupts = <7 4 IRQ_TYPE_EDGE_FALLING>;
+		irq-gpios = <&pio 7 4 GPIO_ACTIVE_HIGH>;	/* CTP-INT: PH4 */
+		reset-gpios = <&pio 7 11 GPIO_ACTIVE_HIGH>;	/* CTP-RST: PH11 */
+		touchscreen-inverted-x;
+		touchscreen-inverted-y;
+	};
+};
+
 &mdio {
 	ext_rgmii_phy: ethernet-phy@1 {
 		compatible = "ethernet-phy-ieee802.3-c22";
@@ -52,6 +68,13 @@
 	regulator-name = "vcc-phy";
 };
 
+&reg_ldo_io0 {
+	regulator-min-microvolt = <2800000>;
+	regulator-max-microvolt = <2800000>;
+	regulator-name = "vdd-ctp";
+	status = "okay";
+};
+
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_pb_pins>;
-- 
2.18.0.321.gffc6fa0e3