[PATCH 5.0 20/32] bnxt_en: Improve multicast address setup logic.

Greg Kroah-Hartman
2019-05-04T10:30:15Z

From: Michael Chan <michael.chan@broadcom.com>

[ Upstream commit b4e30e8e7ea1d1e35ffd64ca46f7d9a7f227b4bf ]

The driver builds a list of multicast addresses and sends it to the
firmware when the driver's ndo_set_rx_mode() is called. In rare
cases, the firmware can fail this call if internal resources to
add multicast addresses are exhausted. In that case, we should
try the call again by setting the ALL_MCAST flag which is more
guaranteed to succeed.

Fixes: c0c050c58d84 ("bnxt_en: New Broadcom ethernet driver.")
Signed-off-by: Michael Chan <michael.chan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
drivers/net/ethernet/broadcom/bnxt/bnxt.c | 9 ++++++++-
1 file changed, 8 insertions(+), 1 deletion(-)

--- a/drivers/net/ethernet/broadcom/bnxt/bnxt.c
+++ b/drivers/net/ethernet/broadcom/bnxt/bnxt.c
@@ -8889,8 +8889,15 @@ static int bnxt_cfg_rx_mode(struct bnxt

skip_uc:
rc = bnxt_hwrm_cfa_l2_set_rx_mask(bp, 0);
+ if (rc && vnic->mc_list_count) {
+ netdev_info(bp->dev, "Failed setting MC filters rc: %d, turning on ALL_MCAST mode\n",
+ rc);
+ vnic->rx_mask |= CFA_L2_SET_RX_MASK_REQ_MASK_ALL_MCAST;
+ vnic->mc_list_count = 0;
+ rc = bnxt_hwrm_cfa_l2_set_rx_mask(bp, 0);
+ }
if (rc)
- netdev_err(bp->dev, "HWRM cfa l2 rx mask failure rc: %x\n",
+ netdev_err(bp->dev, "HWRM cfa l2 rx mask failure rc: %d\n",
rc);

return rc;