[PATCH 2/3] iio: stmpe-adc: Make wait_completion non interruptible

Philippe Schenker
2019-05-03T13:57:44Z

From: Philippe Schenker <philippe.schenker@toradex.com>

In some cases, the wait_completion got interrupted. This caused the
error-handling to mutex_unlock the function. The before turned on
interrupt then got called anyway. In the ISR then completion()
was called causing problems.

Making this wait_completion non interruptible solves the problem.

Signed-off-by: Philippe Schenker <philippe.schenker@toradex.com>
---

drivers/iio/adc/stmpe-adc.c | 6 ++----
1 file changed, 2 insertions(+), 4 deletions(-)

diff --git a/drivers/iio/adc/stmpe-adc.c b/drivers/iio/adc/stmpe-adc.c
index 87141177fbda..baa41ffc0d76 100644
--- a/drivers/iio/adc/stmpe-adc.c
+++ b/drivers/iio/adc/stmpe-adc.c
@@ -78,8 +78,7 @@ static int stmpe_read_voltage(struct stmpe_adc *info,
stmpe_reg_write(info->stmpe, STMPE_REG_ADC_CAPT,
STMPE_ADC_CH(info->channel));

- ret = wait_for_completion_interruptible_timeout
- (&info->completion, STMPE_ADC_TIMEOUT);
+ ret = wait_for_completion_timeout(&info->completion, STMPE_ADC_TIMEOUT);

if (ret <= 0) {
mutex_unlock(&info->lock);
@@ -113,8 +112,7 @@ static int stmpe_read_temp(struct stmpe_adc *info,
stmpe_reg_write(info->stmpe, STMPE_REG_TEMP_CTRL,
STMPE_START_ONE_TEMP_CONV);

- ret = wait_for_completion_interruptible_timeout
- (&info->completion, STMPE_ADC_TIMEOUT);
+ ret = wait_for_completion_timeout(&info->completion, STMPE_ADC_TIMEOUT);

if (ret <= 0) {
mutex_unlock(&info->lock);
--
2.21.0