[PATCH AUTOSEL 4.4 03/92] mmc: core: Verify SD bus width

Sasha Levin
2019-05-22T19:34:19Z

From: Raul E Rangel <rrangel@chromium.org>

[ Upstream commit 9e4be8d03f50d1b25c38e2b59e73b194c130df7d ]

The SD Physical Layer Spec says the following: Since the SD Memory Card
shall support at least the two bus modes 1-bit or 4-bit width, then any SD
Card shall set at least bits 0 and 2 (SD_BUS_WIDTH="0101").

This change verifies the card has specified a bus width.

AMD SDHC Device 7806 can get into a bad state after a card disconnect
where anything transferred via the DATA lines will always result in a
zero filled buffer. Currently the driver will continue without error if
the HC is in this condition. A block device will be created, but reading
from it will result in a zero buffer. This makes it seem like the SD
device has been erased, when in actuality the data is never getting
copied from the DATA lines to the data buffer.

SCR is the first command in the SD initialization sequence that uses the
DATA lines. By checking that the response was invalid, we can abort
mounting the card.

Reviewed-by: Avri Altman <avri.altman@wdc.com>
Signed-off-by: Raul E Rangel <rrangel@chromium.org>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
drivers/mmc/core/sd.c | 8 ++++++++
1 file changed, 8 insertions(+)

diff --git a/drivers/mmc/core/sd.c b/drivers/mmc/core/sd.c
index 967535d76e346..fb8741f18c1f5 100644
--- a/drivers/mmc/core/sd.c
+++ b/drivers/mmc/core/sd.c
@@ -216,6 +216,14 @@ static int mmc_decode_scr(struct mmc_card *card)

if (scr->sda_spec3)
scr->cmds = UNSTUFF_BITS(resp, 32, 2);
+
+ /* SD Spec says: any SD Card shall set at least bits 0 and 2 */
+ if (!(scr->bus_widths & SD_SCR_BUS_WIDTH_1) ||
+ !(scr->bus_widths & SD_SCR_BUS_WIDTH_4)) {
+ pr_err("%s: invalid bus width\n", mmc_hostname(card->host));
+ return -EINVAL;
+ }
+
return 0;
}

--
2.20.1