Re: [PATCH v2 0/7] add Tegra194 XUSB host and pad controller support

Greg KH
2019-10-04T12:23:26Z

On Fri, Oct 04, 2019 at 04:19:34PM +0800, JC Kuo wrote:
> Hi,
>
> This series introduces support for Tegra194 XUSB host and pad
> controller. Tegra194 XUSB host and pad controller are highly
> similar to the controllers found on Tegra186. Therefore, it's
> possible to resue xhci-tegra.c and xusb-tegra186.c for Tegra194.
>
> JC Kuo (7):
> xhci: tegra: Parameterize mailbox register addresses
> usb: host: xhci-tegra: Add Tegra194 XHCI support
> phy: tegra: xusb: Protect Tegra186 soc with config
> phy: tegra: xusb: Add Tegra194 support
> dt-bindings: phy: tegra: Add Tegra194 support
> arm64: tegra: Add XUSB and pad controller on Tegra194
> arm64: tegra: Enable XUSB host in P2972-0000 board

What changed from v1? You need to put that somewhere, usually in the
patches themselves, below the --- line.

Or at the very least, in the cover letter.

Given that I can't find it anywhere here, I'll expect a v3 with that
information to be sent soon :(

thanks,

greg k-h