[Patch v2 07/10] arm: dtsi: dra76x: Add CAL dtsi node

Benoit Parrot
2019-11-04T20:49:25Z

Add the required dtsi node to support the Camera
Adaptation Layer (CAL) for the DRA76 family of devices.

Signed-off-by: Benoit Parrot <bparrot@ti.com>
---
arch/arm/boot/dts/dra76x.dtsi | 43 +++++++++++++++++++++++++++++++++++
1 file changed, 43 insertions(+)

diff --git a/arch/arm/boot/dts/dra76x.dtsi b/arch/arm/boot/dts/dra76x.dtsi
index cdcba3f561c4..2f58c709c081 100644
--- a/arch/arm/boot/dts/dra76x.dtsi
+++ b/arch/arm/boot/dts/dra76x.dtsi
@@ -41,6 +41,49 @@

};

+&l4_per3 {
+ target-module@1b0000 { /* 0x489b0000, ap 25 34.0 */
+ compatible = "ti,sysc-omap4", "ti,sysc";
+ reg = <0x1b0000 0x4>,
+ <0x1b0010 0x4>;
+ reg-names = "rev", "sysc";
+ ti,sysc-midle = <SYSC_IDLE_FORCE>,
+ <SYSC_IDLE_NO>;
+ ti,sysc-sidle = <SYSC_IDLE_FORCE>,
+ <SYSC_IDLE_NO>;
+ clocks = <&cam_clkctrl DRA7_CAM_VIP3_CLKCTRL 0>;
+ clock-names = "fck";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0x0 0x1b0000 0x10000>;
+
+ cal: cal@0 {
+ compatible = "ti,dra76-cal";
+ reg = <0x0000 0x400>,
+ <0x0800 0x40>,
+ <0x0900 0x40>;
+ reg-names = "cal_top",
+ "cal_rx_core0",
+ "cal_rx_core1";
+ interrupts = <GIC_SPI 353 IRQ_TYPE_LEVEL_HIGH>;
+ ti,camerrx-control = <&scm_conf 0x6dc>;
+ status = "disabled";
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ csi2_0: port@0 {
+ reg = <0>;
+ };
+ csi2_1: port@1 {
+ reg = <1>;
+ };
+ };
+ };
+ };
+};
+
/* MCAN interrupts are hard-wired to irqs 67, 68 */
&crossbar_mpu {
ti,irqs-skip = <10 67 68 133 139 140>;
--
2.17.1