[PATCH v2] dt-bindings: i2c: stm32: Migrate i2c-stm32 documentation to yaml

Alain Volmat
2019-11-21T13:28:00Z

The document was migrated to Yaml format and renamed st,stm32-i2c.yaml

Signed-off-by: Alain Volmat <alain.volmat@st.com>
---
v2: remove i2c-scl.*time description, ref (moved into i2c-controller.yaml
push the st,syscfg-fmt into the if compatible st,stm32f7 part
fix the st,syscfg-fmt ref syntax and set minItems/maxItems to 3
make the clock-frequency part common and only keep enum in the st,stm32f4 case
remove unnecesary minItems/maxItems
remove address-cells/size-cells from required fields
---
.../devicetree/bindings/i2c/i2c-stm32.txt | 65 ----------
.../devicetree/bindings/i2c/st,stm32-i2c.yaml | 141 +++++++++++++++++++++
2 files changed, 141 insertions(+), 65 deletions(-)
delete mode 100644 Documentation/devicetree/bindings/i2c/i2c-stm32.txt
create mode 100644 Documentation/devicetree/bindings/i2c/st,stm32-i2c.yaml

diff --git a/Documentation/devicetree/bindings/i2c/i2c-stm32.txt b/Documentation/devicetree/bindings/i2c/i2c-stm32.txt
deleted file mode 100644
index ce3df2fff6c8..000000000000
--- a/Documentation/devicetree/bindings/i2c/i2c-stm32.txt
+++ /dev/null
@@ -1,65 +0,0 @@
-* I2C controller embedded in STMicroelectronics STM32 I2C platform
-
-Required properties:
-- compatible: Must be one of the following
- - "st,stm32f4-i2c"
- - "st,stm32f7-i2c"
-- reg: Offset and length of the register set for the device
-- interrupts: Must contain the interrupt id for I2C event and then the
- interrupt id for I2C error.
-- resets: Must contain the phandle to the reset controller.
-- clocks: Must contain the input clock of the I2C instance.
-- A pinctrl state named "default" must be defined to set pins in mode of
- operation for I2C transfer
-- #address-cells = <1>;
-- #size-cells = <0>;
-
-Optional properties:
-- clock-frequency: Desired I2C bus clock frequency in Hz. If not specified,
- the default 100 kHz frequency will be used.
- For STM32F4 SoC Standard-mode and Fast-mode are supported, possible values are
- 100000 and 400000.
- For STM32F7, STM32H7 and STM32MP1 SoCs, Standard-mode, Fast-mode and Fast-mode
- Plus are supported, possible values are 100000, 400000 and 1000000.
-- dmas: List of phandles to rx and tx DMA channels. Refer to stm32-dma.txt.
-- dma-names: List of dma names. Valid names are: "rx" and "tx".
-- i2c-scl-rising-time-ns: I2C SCL Rising time for the board (default: 25)
- For STM32F7, STM32H7 and STM32MP1 only.
-- i2c-scl-falling-time-ns: I2C SCL Falling time for the board (default: 10)
- For STM32F7, STM32H7 and STM32MP1 only.
- I2C Timings are derived from these 2 values
-- st,syscfg-fmp: Use to set Fast Mode Plus bit within SYSCFG when Fast Mode
- Plus speed is selected by slave.
- 1st cell: phandle to syscfg
- 2nd cell: register offset within SYSCFG
- 3rd cell: register bitmask for FMP bit
- For STM32F7, STM32H7 and STM32MP1 only.
-
-Example:
-
- i2c@40005400 {
- compatible = "st,stm32f4-i2c";
- #address-cells = <1>;
- #size-cells = <0>;
- reg = <0x40005400 0x400>;
- interrupts = <31>,
- <32>;
- resets = <&rcc 277>;
- clocks = <&rcc 0 149>;
- pinctrl-0 = <&i2c1_sda_pin>, <&i2c1_scl_pin>;
- pinctrl-names = "default";
- };
-
- i2c@40005400 {
- compatible = "st,stm32f7-i2c";
- #address-cells = <1>;
- #size-cells = <0>;
- reg = <0x40005400 0x400>;
- interrupts = <31>,
- <32>;
- resets = <&rcc STM32F7_APB1_RESET(I2C1)>;
- clocks = <&rcc 1 CLK_I2C1>;
- pinctrl-0 = <&i2c1_sda_pin>, <&i2c1_scl_pin>;
- pinctrl-names = "default";
- st,syscfg-fmp = <&syscfg 0x4 0x1>;
- };
diff --git a/Documentation/devicetree/bindings/i2c/st,stm32-i2c.yaml b/Documentation/devicetree/bindings/i2c/st,stm32-i2c.yaml
new file mode 100644
index 000000000000..900ec1ab6a47
--- /dev/null
+++ b/Documentation/devicetree/bindings/i2c/st,stm32-i2c.yaml
@@ -0,0 +1,141 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/i2c/st,stm32-i2c.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: I2C controller embedded in STMicroelectronics STM32 I2C platform
+
+maintainers:
+ - Pierre-Yves MORDRET <pierre-yves.mordret@st.com>
+
+allOf:
+ - $ref: /schemas/i2c/i2c-controller.yaml#
+ - if:
+ properties:
+ compatible:
+ contains:
+ enum:
+ - st,stm32f7-i2c
+ then:
+ properties:
+ i2c-scl-rising-time-ns:
+ default: 25
+
+ i2c-scl-falling-time-ns:
+ default: 10
+
+ st,syscfg-fmp:
+ description: Use to set Fast Mode Plus bit within SYSCFG when
+ Fast Mode Plus speed is selected by slave.
+ Format is phandle to syscfg / register offset within
+ syscfg / register bitmask for FMP bit.
+ allOf:
+ - $ref: "/schemas/types.yaml#/definitions/phandle-array"
+ - items:
+ minItems: 3
+ maxItems: 3
+
+ - if:
+ properties:
+ compatible:
+ contains:
+ enum:
+ - st,stm32f4-i2c
+ then:
+ properties:
+ clock-frequency:
+ enum: [100000, 400000]
+
+properties:
+ compatible:
+ enum:
+ - st,stm32f4-i2c
+ - st,stm32f7-i2c
+
+ reg:
+ maxItems: 1
+
+ interrupts:
+ items:
+ - description: interrupt ID for I2C event
+ - description: interrupt ID for I2C error
+
+ resets:
+ maxItems: 1
+
+ clocks:
+ maxItems: 1
+
+ dmas:
+ items:
+ - description: RX DMA Channel phandle
+ - description: TX DMA Channel phandle
+
+ dma-names:
+ items:
+ - const: rx
+ - const: tx
+
+ clock-frequency:
+ description: Desired I2C bus clock frequency in Hz. If not specified,
+ the default 100 kHz frequency will be used.
+ For STM32F7, STM32H7 and STM32MP1 SoCs, Standard-mode,
+ Fast-mode and Fast-mode Plus are supported, possible
+ values are 100000, 400000 and 1000000.
+ default: 100000
+ enum: [100000, 400000, 1000000]
+
+required:
+ - compatible
+ - reg
+ - interrupts
+ - resets
+ - clocks
+
+examples:
+ - |
+ #include <dt-bindings/mfd/stm32f7-rcc.h>
+ #include <dt-bindings/clock/stm32fx-clock.h>
+ //Example 1 (with st,stm32f4-i2c compatible)
+ i2c@40005400 {
+ compatible = "st,stm32f4-i2c";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0x40005400 0x400>;
+ interrupts = <31>,
+ <32>;
+ resets = <&rcc 277>;
+ clocks = <&rcc 0 149>;
+ };
+
+ //Example 2 (with st,stm32f7-i2c compatible)
+ i2c@40005800 {
+ compatible = "st,stm32f7-i2c";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0x40005800 0x400>;
+ interrupts = <31>,
+ <32>;
+ resets = <&rcc STM32F7_APB1_RESET(I2C1)>;
+ clocks = <&rcc 1 CLK_I2C1>;
+ };
+
+ //Example 3 (with st,stm32f7-i2c compatible on stm32mp)
+ #include <dt-bindings/interrupt-controller/arm-gic.h>
+ #include <dt-bindings/clock/stm32mp1-clks.h>
+ #include <dt-bindings/reset/stm32mp1-resets.h>
+ i2c@40013000 {
+ compatible = "st,stm32f7-i2c";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0x40013000 0x400>;
+ interrupts = <GIC_SPI 33 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 34 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&rcc I2C2_K>;
+ resets = <&rcc I2C2_R>;
+ i2c-scl-rising-time-ns = <185>;
+ i2c-scl-falling-time-ns = <20>;
+ st,syscfg-fmp = <&syscfg 0x4 0x2>;
+ };
+...
--
2.7.4