Re: [PATCH v3] pinctrl: qcom: use scm_call to route GPIO irq to Apps

[Bjorn Andersson <bjorn.andersson@linaro.org>]

On Fri 27 Mar 15:32 PDT 2020, Ansuel Smith wrote:

> From: Ajay Kishore <akisho@codeaurora.org>
> 
> For IPQ806x targets, TZ protects the registers that are used to
> configure the routing of interrupts to a target processor.
> To resolve this, this patch uses scm call to route GPIO interrupts
> to application processor. Also the scm call interface is changed.
> 
> Signed-off-by: Ajay Kishore <akisho@codeaurora.org>
> Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>

Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>

Thanks,
Bjorn

> ---
> v3:
> * Rename route_to_apps to intr_target_use_scm
> * Follow standard design and rename base_reg to phys_base
> * Add additional comments in route interrupts condition 
> 
> v2:
> * Move static varibale in msm_pinctrl struct
> * Revert '4b024225c4a8 ("pinctrl: use devm_platform_ioremap_resource() to simplify code")'
>   to get base_reg addr
> 
>  drivers/pinctrl/qcom/pinctrl-msm.c | 42 +++++++++++++++++++++++++-----
>  1 file changed, 36 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/pinctrl/qcom/pinctrl-msm.c b/drivers/pinctrl/qcom/pinctrl-msm.c
> index 9a8daa256a32..7d2a34beb1b6 100644
> --- a/drivers/pinctrl/qcom/pinctrl-msm.c
> +++ b/drivers/pinctrl/qcom/pinctrl-msm.c
> @@ -22,6 +22,8 @@
>  #include <linux/reboot.h>
>  #include <linux/pm.h>
>  #include <linux/log2.h>
> +#include <linux/qcom_scm.h>
> +#include <linux/io.h>
>  
>  #include <linux/soc/qcom/irq.h>
>  
> @@ -60,6 +62,8 @@ struct msm_pinctrl {
>  	struct irq_chip irq_chip;
>  	int irq;
>  
> +	bool intr_target_use_scm;
> +
>  	raw_spinlock_t lock;
>  
>  	DECLARE_BITMAP(dual_edge_irqs, MAX_NR_GPIO);
> @@ -68,6 +72,7 @@ struct msm_pinctrl {
>  
>  	const struct msm_pinctrl_soc_data *soc;
>  	void __iomem *regs[MAX_NR_TILES];
> +	u32 phys_base[MAX_NR_TILES];
>  };
>  
>  #define MSM_ACCESSOR(name) \
> @@ -882,11 +887,31 @@ static int msm_gpio_irq_set_type(struct irq_data *d, unsigned int type)
>  	else
>  		clear_bit(d->hwirq, pctrl->dual_edge_irqs);
>  
> -	/* Route interrupts to application cpu */
> -	val = msm_readl_intr_target(pctrl, g);
> -	val &= ~(7 << g->intr_target_bit);
> -	val |= g->intr_target_kpss_val << g->intr_target_bit;
> -	msm_writel_intr_target(val, pctrl, g);
> +	/* Route interrupts to application cpu.
> +	 * With intr_target_use_scm interrupts are routed to
> +	 * application cpu using scm calls.
> +	 */
> +	if (pctrl->intr_target_use_scm) {
> +		u32 addr = pctrl->phys_base[0] + g->intr_target_reg;
> +		int ret;
> +
> +		qcom_scm_io_readl(addr, &val);
> +
> +		val &= ~(7 << g->intr_target_bit);
> +		val |= g->intr_target_kpss_val << g->intr_target_bit;
> +
> +		ret = qcom_scm_io_writel(addr, val);
> +		if (ret)
> +			dev_err(pctrl->dev,
> +				"Failed routing %lu interrupt to Apps proc",
> +				d->hwirq);
> +		}
> +	} else {
> +		val = msm_readl_intr_target(pctrl, g);
> +		val &= ~(7 << g->intr_target_bit);
> +		val |= g->intr_target_kpss_val << g->intr_target_bit;
> +		msm_writel_intr_target(val, pctrl, g);
> +	}
>  
>  	/* Update configuration for gpio.
>  	 * RAW_STATUS_EN is left on for all gpio irqs. Due to the
> @@ -1241,6 +1266,9 @@ int msm_pinctrl_probe(struct platform_device *pdev,
>  	pctrl->dev = &pdev->dev;
>  	pctrl->soc = soc_data;
>  	pctrl->chip = msm_gpio_template;
> +	pctrl->intr_target_use_scm = of_device_is_compatible(
> +					pctrl->dev->of_node,
> +					"qcom,ipq8064-pinctrl");
>  
>  	raw_spin_lock_init(&pctrl->lock);
>  
> @@ -1253,9 +1280,12 @@ int msm_pinctrl_probe(struct platform_device *pdev,
>  				return PTR_ERR(pctrl->regs[i]);
>  		}
>  	} else {
> -		pctrl->regs[0] = devm_platform_ioremap_resource(pdev, 0);
> +		res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> +		pctrl->regs[0] = devm_ioremap_resource(&pdev->dev, res);
>  		if (IS_ERR(pctrl->regs[0]))
>  			return PTR_ERR(pctrl->regs[0]);
> +
> +		pctrl->phys_base[0] = res->start;
>  	}
>  
>  	msm_pinctrl_setup_pm_reset(pctrl);
> -- 
> 2.25.1
>