Re: [Outreachy kernel] [PATCH] staging: emxx_udc: Remove unused code

[Stefano Brivio <sbrivio@redhat.com>]

On Wed,  1 Apr 2020 19:17:06 -0700
"John B. Wyatt IV" <jbwyatt4@gmail.com> wrote:

> Remove unused code surrounded by an #if 0 block.
> 
> Code has not been altered since 2014 as reported by git blame.
> 
> Reported by checkpatch.
> 
> Signed-off-by: John B. Wyatt IV <jbwyatt4@gmail.com>
> ---
>  drivers/staging/emxx_udc/emxx_udc.h | 6 ------
>  1 file changed, 6 deletions(-)
> 
> diff --git a/drivers/staging/emxx_udc/emxx_udc.h b/drivers/staging/emxx_udc/emxx_udc.h
> index 9c2671cb32f7..bbfebe331033 100644
> --- a/drivers/staging/emxx_udc/emxx_udc.h
> +++ b/drivers/staging/emxx_udc/emxx_udc.h
> @@ -9,12 +9,6 @@
>  #define _LINUX_EMXX_H
>  
>  /*---------------------------------------------------------------------------*/
> -/*----------------- Default undef */
> -#if 0
> -#define DEBUG
> -#define UDC_DEBUG_DUMP
> -#endif
> -
>  /*----------------- Default define */
>  #define	USE_DMA	1
>  #define USE_SUSPEND_WAIT	1

Formally, this is fine. But... think about it: this driver might be
rather buggy, so the first thing one might want to do with it is to
"enable" those two defines.

In general, that stuff has to disappear, and proper debugging
facilities have to be used, but with a driver in this state, as long as
proper debugging facilities aren't there, you might be doing more harm
than good.

-- 
Stefano