[PATCH net-next v8 0/5] RGMII Internal delay common property

Dan Murphy
2020-06-18T21:10:28Z

Hello

The RGMII internal delay is a common setting found in most RGMII capable PHY
devices. It was found that many vendor specific device tree properties exist
to do the same function. This creates a common property to be used for PHY's
that have internal delays for the Rx and Tx paths.

If the internal delay is tunable then the caller needs to pass the internal
delay array and the return will be the index in the array that was found in
the firmware node.

If the internal delay is fixed then the caller only needs to indicate which
delay to return. There is no need for a fixed delay to add device properties
since the value is not configurable. Per the ethernet-controller.yaml the
interface type indicates that the PHY should provide the delay.

This series contains examples of both a configurable delay and a fixed delay.

Dan Murphy (5):
dt-bindings: net: Add tx and rx internal delays
net: phy: Add a helper to return the index for of the internal delay
dt-bindings: net: Add RGMII internal delay for DP83869
net: dp83869: Add RGMII internal delay configuration
net: phy: DP83822: Add setting the fixed internal delay

.../devicetree/bindings/net/ethernet-phy.yaml | 13 +++
.../devicetree/bindings/net/ti,dp83869.yaml | 16 ++-
drivers/net/phy/dp83822.c | 78 ++++++++++++--
drivers/net/phy/dp83869.c | 53 +++++++++-
drivers/net/phy/phy_device.c | 100 ++++++++++++++++++
include/linux/phy.h | 4 +
6 files changed, 250 insertions(+), 14 deletions(-)

--
2.26.2