[RFT PATCH v5] serial: samsung: Removes the IRQ not found warning

Tamseel Shams
2020-08-10T04:08:35Z

In few older Samsung SoCs like s3c2410, s3c2412
and s3c2440, UART IP is having 2 interrupt lines.
However, in other SoCs like s3c6400, s5pv210,
exynos5433, and exynos4210 UART is having only 1
interrupt line. Due to this, "platform_get_irq(platdev, 1)"
call in the driver gives the following false-positive error:
"IRQ index 1 not found" on newer SoC's.

This patch adds the condition to check for Tx interrupt
only for the those SoC's which have 2 interrupt lines.

Signed-off-by: Tamseel Shams <m.shams@samsung.com>
---
Commit message is changed.

Added RFT, for older platform.

Addressed Krzysztof's review comments [1]
[1] -> https://lkml.org/lkml/2020/7/21/150

drivers/tty/serial/samsung_tty.c | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/tty/serial/samsung_tty.c b/drivers/tty/serial/samsung_tty.c
index 6ef614d8648c..b923683e6a25 100644
--- a/drivers/tty/serial/samsung_tty.c
+++ b/drivers/tty/serial/samsung_tty.c
@@ -1911,9 +1911,11 @@ static int s3c24xx_serial_init_port(struct s3c24xx_uart_port *ourport,
ourport->tx_irq = ret + 1;
}

- ret = platform_get_irq(platdev, 1);
- if (ret > 0)
- ourport->tx_irq = ret;
+ if (!s3c24xx_serial_has_interrupt_mask(port)) {
+ ret = platform_get_irq(platdev, 1);
+ if (ret > 0)
+ ourport->tx_irq = ret;
+ }
/*
* DMA is currently supported only on DT platforms, if DMA properties
* are specified.
--
2.17.1