Re: [PATCH 6/7] arm64: dts: ti: k3-*: Use generic adc for node names

Vignesh Raghavendra
2020-09-03T05:25:25Z

Hi Nishanth,

On 9/2/20 11:48 PM, Nishanth Menon wrote:
> On 11:51-20200902, Suman Anna wrote:
>> On 9/1/20 5:30 PM, Nishanth Menon wrote:
>>> Use adc@ naming for nodes following standard conventions of device
>>> tree (section 2.2.2 Generic Names recommendation in [1]).
>>>
>>> [1] https://github.com/devicetree-org/devicetree-specification/tree/v0.3
>>>
>>> Suggested-by: Suman Anna <s-anna@ti.com>
>>> Signed-off-by: Nishanth Menon <nm@ti.com>
>>> ---
>>> arch/arm64/boot/dts/ti/k3-am65-mcu.dtsi | 4 ++--
>>> arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi | 4 ++--
>>> 2 files changed, 4 insertions(+), 4 deletions(-)
>>>
>>> diff --git a/arch/arm64/boot/dts/ti/k3-am65-mcu.dtsi b/arch/arm64/boot/dts/ti/k3-am65-mcu.dtsi
>>> index 51ca4b4d4c21..6dfec68ac865 100644
>>> --- a/arch/arm64/boot/dts/ti/k3-am65-mcu.dtsi
>>> +++ b/arch/arm64/boot/dts/ti/k3-am65-mcu.dtsi
>>> @@ -80,7 +80,7 @@
>>> #size-cells = <0>;
>>> };
>>>
>>> - tscadc0: tscadc@40200000 {
>>> + tscadc0: adc@40200000 {
>>
>> OK with these changes, since these seem to be only have the adc child nodes.
>> This node is essentially a parent node for touchscreen and adc child nodes. The
>> driver is currently looking for "tsc" on touchscreen child nodes, but none of
>> the K3 SoCs have them atm.
>>
>
>
> Vignesh: are you ok with this, care to comment?
>

On K3 SoCs, ADC IP is reuse from AM335x but just lacks resistive
touchscreen interfaces. So, existing AM335x ADC driver is being reused
for K3 devices as well. Unfortunately, ADC driver cannot be used as
standalone and is dependent on MFD parent to be present...
Above node represents the MFD parent and ADC itself is the child node
(see arch/arm64/boot/dts/ti/k3-am654-base-board.dts). So, I recommend
that we keep this node's name as tscadc in order to avoid having same
name for parent and child node which will be quite confusing.

Regards
Vignesh