[PATCH v5 28/36] i2c: tegra: Check errors for both positive and negative values

Dmitry Osipenko
2020-09-06T18:53:02Z

The driver's code is inconsistent in regards to the error values checking.
The correct way should be to check both positive and negative values.
This patch cleans up the error-checks in the code. Note that the
pm_runtime_get_sync() could return positive value on success, hence only
relevant parts of the code are changed by this patch.

Reviewed-by: Michał Mirosław <mirq-linux@rere.qmqm.pl>
Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
---
drivers/i2c/busses/i2c-tegra.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c
index d34b6bb295b9..68becf9da9e1 100644
--- a/drivers/i2c/busses/i2c-tegra.c
+++ b/drivers/i2c/busses/i2c-tegra.c
@@ -963,7 +963,7 @@ static int tegra_i2c_config_fifo_trig(struct tegra_i2c_dev *i2c_dev, size_t len)

slv_config.device_fc = true;
ret = dmaengine_slave_config(chan, &slv_config);
- if (ret < 0) {
+ if (ret) {
dev_err(i2c_dev->dev, "DMA slave config failed: %d\n",
ret);
return ret;
@@ -1205,7 +1205,7 @@ static int tegra_i2c_xfer_msg(struct tegra_i2c_dev *i2c_dev,
xfer_size,
DMA_FROM_DEVICE);
err = tegra_i2c_dma_submit(i2c_dev, xfer_size);
- if (err < 0) {
+ if (err) {
dev_err(i2c_dev->dev,
"starting RX DMA failed, err %d\n",
err);
@@ -1230,7 +1230,7 @@ static int tegra_i2c_xfer_msg(struct tegra_i2c_dev *i2c_dev,
xfer_size,
DMA_TO_DEVICE);
err = tegra_i2c_dma_submit(i2c_dev, xfer_size);
- if (err < 0) {
+ if (err) {
dev_err(i2c_dev->dev,
"starting TX DMA failed, err %d\n",
err);
--
2.27.0