Re: [RFC PATCH V3 13/21] mmc: sdhci: UHS-II support, skip signal_voltage_switch()

[AKASHI Takahiro <takahiro.akashi@linaro.org>]

Adrian,

On Fri, Aug 21, 2020 at 05:09:01PM +0300, Adrian Hunter wrote:
> On 10/07/20 2:11 pm, Ben Chuang wrote:
> > From: AKASHI Takahiro <takahiro.akashi@linaro.org>
> > 
> > sdhci_start_signal_voltage_switch() should be called only in UHS-I mode,
> > and not for UHS-II mode.
> > 
> > Signed-off-by: Ben Chuang <ben.chuang@genesyslogic.com.tw>
> > Signed-off-by: AKASHI Takahiro <takahiro.akashi@linaro.org>
> > ---
> >  drivers/mmc/host/sdhci.c | 7 ++++++-
> >  1 file changed, 6 insertions(+), 1 deletion(-)
> > 
> > diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
> > index 5511649946b9..7f2537648a08 100644
> > --- a/drivers/mmc/host/sdhci.c
> > +++ b/drivers/mmc/host/sdhci.c
> > @@ -2623,8 +2623,13 @@ int sdhci_start_signal_voltage_switch(struct mmc_host *mmc,
> >  	/*
> >  	 * Signal Voltage Switching is only applicable for Host Controllers
> >  	 * v3.00 and above.
> > +	 * But for UHS2, the signal voltage is supplied by vdd2 which is
> > +	 * already 1.8v so no voltage switch required.
> >  	 */
> > -	if (host->version < SDHCI_SPEC_300)
> > +	if (host->version < SDHCI_SPEC_300 ||
> > +	    (IS_ENABLED(CONFIG_MMC_SDHCI_UHS2) &&
> > +	     host->version >= SDHCI_SPEC_400 &&
> > +	     host->mmc->flags & MMC_UHS2_SUPPORT))
> 
> Please look at hooking ->start_signal_voltage_switch() instead

Do you mean that you want every platform driver who wants to support UHS-II
to set NULL to start_signal_voltage_switch hook even if this hack is
platform agnostic?
(Another option is that it would be put in sdhci_uhs2_add_host() which
is responsible to set MMC_UHS2_SUPPORT.)

-Takahiro Akashi

> 
> 
> >  		return 0;
> >  
> >  	ctrl = sdhci_readw(host, SDHCI_HOST_CONTROL2);
> > 
>